Introduction - CAESAR II | CAESAR II Webinar | Introduction to Pipe Stress Analysis

[@Frankb932]

hello, I have a question: Why when Caesar II run the stress report in some cases the Allowable Stress in the entire table is 0 and the Ratio % is 0 too. But in other case LoadCase (W+P1) the Allowable Stress is different to 0. Why happens that? There is an error?

[@Frankb932]

Why in the LoadCases (OPE) the Allowable Stress is 0 in the Stress reports?

[@ktzsikka]

Because there is no stress called as OPERATING STRESS.( refer to b 31.3) Operating cases are only made to check loads and displacements....at nozzles, supports, anchors, etc.

[@aliabdulkadhumali243]

how you mention that crude is heavier than water ? crude density is 800 kg/m3 while for water is 1000 !

[@XxSniper32]

Is there any more webinars about CAESAR II?

[@TheMultisoftsystems]

Yes , please go our website- multisoftsystems.com

[@egbukaanayo723]

Can I download the free software for installation?

[@TheMultisoftsystems]

its paid software if you needed please visit our website

[@sujalpawar8664]

is this full course

[@TheMultisoftsystems]

its webinar if you are more information please visit- multisoftsystems.com