Introduction to the Eastwood Elite 4'x4' CNC Plasma Table Controls

[@IbrahimAbdulfatai-de2xc]

Thank you very much.but my cnc is piercing the same place instead of moving i would be glad if you can guide me through

[@firasmakni-uk8zw]

Big thx from tunisia

[@weldinggirl]

Man I really wish I had one of these tables 😍😍

[@IbrahimAbdulfatai-de2xc]

How can i factory resets my cnc?

[@raulf779]

What automotive applications this have? Any real life examples for using for vehicle mods?

[@gagcengineeringgeita1023]

Problem with my CNC PLASMA cutting machine.....I need a help. It peirces but no moving ...but when do Demo is moving.....at the same time if using flame cut it cuts very good like before....... When I switch to palsma it makes a peirce on the material but no moving.....I checked all the safety devices /fuses are all ok from the plasma source but no moving when I command...... Please assist me while I am planning to get the bigger machine this year from you.....i followed the videos in KZbin I am using Huyuan Plasma power source Huyuan IGBT 200A *Simply.... torch does not move after initial pierce*

[@eastwoodco]

I'll reach out to our technical team but are you working with an Eastwood Plasma Table?

[@phillipandis9691]

Hi how do I bring up the alphabet to name a file that I have imported from a usb Please advise Kind regards Phil in Australia 10 am 3:02 3:02

[@lovelaceanyormi8598]

Please my panel is not in English how would I change it

[@eastwoodco]

[Yesterday 2:00 PM] Nick Cornell Page 22 of manual last bullet To change the machine’s unit setting from the diagnose menu, go to the F8 System Def (FIG 26) then F3 Define and enter the password “1396” (FIG 27). With the correct password entered, navigating to F5 Option (FIG 28) will open a menu that includes the option to switch units listed as Default Unit (FIG 28). The machine power must be cycled to put this change in effect.

[@israelgiovanny]

En español tienes audio

[@darleenpalmieri7255]

We don't have F8 on our CnC so how do I change MM to Inches

[@eastwoodco]

Is your CNC an Eastwood Table?

[@darleenpalmieri7255]

Yes

[@eastwoodco]

I believe that means you have our versa-Cut table. To switch he needs to press F4 > F3 it will be a blank screen and press "1928" on the keypad. A window will pop up and the last option is to switch between units. There's a firmware update for this machine if it was purchased before March - please email [e-mail] and he'll get you all straightened out.

[@maxgluhih2704]

there is a link to the software or firmware please

[@eastwoodco]

Do you own the table and need the update?

[@isaacajo3142]

Huayuan welder Serial num: 3853D070 Type: F1621P V3.1 demanding for password and won't boot

[@eastwoodco]

You'll need to contact the manufacturer - that's not an Eastwood product.