iPad Air Digitizer Replacement (Glass Only Repair) - DIY 30-40 Mins

[@federal7194]

This glass only repair was obviously done on an iPad Air as the titled stated! But please keep in mind the iPad air 2's glass replacements are much more difficult and not as easy as an iPad Air. Please do not attempt an iPad Air 2's glass replacement only, yourself! An iPad Air 2's glass replacement takes an experienced technician with professional heating equipment to complete it safely and properly. Good job on this repair but it is by far one of the easier iPads to do this type of repair as stated in this video. Good Day to all!

[@keithnoneya]

THUMBS UP! The BEST ONE I've seen yet with tips and tricks and complete. Thanks for sharing. Best Wishes & Blessings. Keith Noneya

[@htcworld2011]

Slightly confused. I will be doing this task on an iPad air 2. So I have been told that both the digitiser and the LCD are connected together. From your video it looks like they are 2 separate pieces. Does this video only apply for the iPad air first generation?

[@danielpisano3347]

Do i need the black tape for the home button cable? I lost mine.

[@keenonjazz]

Brilliant and helpful video.I've demaged a conector while I was trying to change my LCD,in your video is at 7:53 mins,do you think that can be replaced? Thanks

[@cathynovosad1910]

I dropped my 64 GB ipad air 2 (Model MH182CL/A). The glass is NOT broken but the screen brightness is effected with two grey streaks running up the long side of the screen. Which part(s) would I need to order and replace?

[@jamesbullock9209]

You'll have to replace the LCD/digitizer assembly. Just type in "Ipad Air 2 model a1670, a1671, or a1821 lcd/digitizer replacement". It's not a hard repair for anyone experienced, but the part can be quite expensive. Good luck!

[@ΓεωργιοςΣανοπουλος]

Hello iPad Air 2 broken screen glass can I send it to you for repair

[@Christian_Luczejko]

Is this the original iPad Air or the iPad Air 2. I am looking into doing a screen replacement as I cracked the glass on my iPad Air 2 last night. But I'm confused by reading different reports saying that the iPad Air 2 cannot have just the glass replaced because the lcd is now attached to the glass. Any help would be greatly appreciated.

[@rishardlampese8947]

I'm replying 5 years later in case anyone new watching this has the same question. This is the original iPad Air 1st generation. You can tell by the main button with the printed square symbol on it.

[@jc30005]

What about the home button? How does it attach. Also is this the same for the air 2?

[@mparagames]

The LCD is attached to the digitalizer in air 2.

[@enzo655]

Thank you just waiting for the glass screen to change this same iPad I’m texting, very helpful. I changed the glass of iPad 3, works fine, I hope this one would be the same. Is really necessary to use the double sided tape, as the screen come with adhesive around already?

[@MrsTracey617]

Hi do u respond to comments?? This video is old.... Anyway.. My daughters iPad cracked! Everything still works.. But the screen is mangled obviously.. So do I only need a screen?? Or what is the digitizer.. do I need that too? Or is it safe just to get a screen? It looks just like yours in this video thank you so much

[@peridinium5622]

Just repair it

[@rafsab8]

a digitizer is the top screen ( front glass ) touch screen lcd sits under that - in your case u need to replace the top screen the digitizer

[@jdunst69]

Except for the part where it is super easy to damage your lcd screen underneath if your first prying technique goes 1 millimeter past the glue. So yeah you can damage more then the ribbon cable. My lcd is toast now. Just be aware

[@rattus1575]

Just replaced the screen for my iPad Air, and the part on the right where the ribbon cables are on the digitizer seem to be pushing the screen upwards and slowly prying it open again... not sure what to do about that other than just using a protective case that holds it down. Other than that, the new screen replacement seems to be working fine.

[@MtBArN]

Thanks for the video mate, works like a charm!

[@mortonnewton1692]

I noticed that there was adhesive tape and on the screen. How did u fix it. I am currently stuck on that problem

[@ErCellutions]

+Morton Newton the double sided tape has gotten on the screen?

[@hamdankhan1337]

You don’t have to unground the iPad?

[@gemmahong6450]

Thank you for sharing your talent!

[@tambell6270]

Be advised that the iPad A1674 lcd is glued to the glass digitiser and not held by 4 screws, unfortunately it was my first time to replace the glass and ended up having to replace the lcd/glass combined. Don’t know why Amazon sell the glass as a replaceable item ? 🤬🤬🤬

[@krisgomez6320]

Ur video was the best 💖

[@nickycoleman]

Thanks.

[@buddestry76]

After iPad Air the digitiser is loca glued to the screen so not all similar

[@MattiasDavidsson]

So, you cut the part out where you actually fit the screen on. So, I do not know where the cable to the home button goes...

[@boogielix3602]

thank you

[@kingvines5086]

wow thanks allot

[@gomathiramachandran809]

Where to get glass anyidea

[@jessicasessler8398]

Gomathi Ramachandran I ordered one on Amazon for $35. Just look up “iPad screen repair kit.” I got one through a place called Repair Parts Plus.

[@paulsmith_07]

thank

[@phillipgunner6902]

Yes you help me can you a ipad pro pls

[@Supersabha1]

IS this AIR PAD 2 ??

[@twodankfourtheletteru5156]

mahmoud sabha no

[@ltamborrell1]

you did not cover the part of the sensor, I know that when you change the touchscreen you have to cover the sensor and right now I have that problem

[@KMNone-wc6si]

Luis Tamborrell what do you mean cover the sensor? I want to know so I don't screw anything up.

[@राजेदरकुमारराजेदरकुमार-न8ट]

Airparrot model iPad case

[@Ahmed-Muflahi]

I listened your whole video now my ipad is broken

[@YenDo-cz6xx]

Hi

[@deathgear8907]

One thing I have been trying to find a person who can fix my iPad screen and home button and I don’t know what to do

[@yuionibi9776]

You cant fit the home button without calibrating the part only techs or apple can do that

[@YenDo-cz6xx]

I cracked my iPad by dropping it won't

[@ios6605]

Good video but you left out a very important part and that is reinserting the plug for the home button and showing how that connector locks down . I was waiting the whole video for that part 🤬🤬🤬

[@xanderph2999]

[5:38] Face reveal

[@08turboSS]

Not a good diy repair video.

[@8Millimetre]

Thank you