iPad Pro 11'' 3rd gen. Screen Replacement📲 How to avoid dead logic board

📲 Below, I leave some links for the iPad Pro screens:
s.click.aliexp...
s.click.aliexp...
s.click.aliexp...
s.click.aliexp...
s.click.aliexp...
s.click.aliexp...
Repair iPad Pro 11 inch 3.ª generación, A2377, A2459, A2301, A2460 screen correctly. In this video we are going to see step by step the whole process to replace the screen of this iPad. We are even going to teach you how to lift any broken screen without damaging it and thus repair it later.
❤️ Tools👉👉 movilone.eu
You Can Be Membership Here
/ moviloneesgranada

[@Muffinsmasher]

One of the only realistic repair video's I've seen. Someone struggling for 20 min trying to open the glass, happens every time. I hate doing iPads.

[@starlite3597]

apply slight heat

[@ate810]

What tool size did you use for the screws on the inside of the iPad I wanna make sure I get the right thing

[@xx3868]

Hi, is the ipad Mini 1 screens the same as the mini 2 to swap over? or is there diff's . Thanks

[@MDTrepairs]

Buen video, solo como observación lo siguiente : no meter la cuña justo debajo de los pines de la batería ya que se pueden dañar.

[@CarlosPires-du3ps]

what are the drawbacks of not using an OEM screen?

[@seanjerome1]

You will not be able to buy any OEM parts for apple. They do not consent to anyone repairing their products besides their own repair shops.

[@alexosow]

Do you know if a 2020 or 2018 iPad LCD screen will also work? It looks like the same thing

[@irepairofpc31familykartrac51]

No it will not work.

[@rafalaugustyniak9329]

i think you said one word incorrectly and that confused me a little bit. you said that we need to review “broken” screen but i think it should be: “ review new screen “

[@PhoneRepairs-m2n]

does it give you the message " the iPad cant verify if the screen is an apple genuine" ??

[@sonofken]

No

[@PhoneRepairs-m2n]

@@sonofken thank you

[@jennajone45]

What song is this lol

[@chrisd8006]

I dont understand how you Raise the battery connector with just a plastic pry tool...I'm trying it with a iPad pro and it's not anywhere near as easy as this video makes it out to be

[@chadmccollister]

I use a much thinner plastic card cut to about 2 inches wide with a notch cut in it to straddle the battery screw post. (google iPad battery block to see). Unless you have an ultra thin guitar pick, it's very difficult with any heavier plastic pick. The best battery block will have a notch cut in it to straddle the screw mount post once you remove the screw, you should be able to slowly work it between the logic board and battery board. Slight heat may help in some circumstances where it is extra tough because the logic board has adhesive also holding it down to the rear housing too, not just the screw. I have had a few iPad where I applied light heat to the backside of the housing to loosen the adhesive that is between the housing and logic board and the battery block would slide in much easier.

[@marcingogowski6077]

I don't like this video. You didn't show how to glue the glass

[@MannyVel]

Great technical video...... but can't stand the 'egotistically negative impulsive music'. Manny (guitar/keyboard player - rock, blues, jazz, celtic, indian, latin, ambient musical influences)