Is my transom bad? Do I need to repair or replace it? Taking a closer look at my transom

  Рет қаралды 61,025

Wayne The Boat Guy

Wayne The Boat Guy

Күн бұрын

Пікірлер: 45
@Paidtimeoff47
@Paidtimeoff47 4 жыл бұрын
If you take a ball ping hammer and just lightly tap on the transom itll make a sharp pinging sound if the transom is good. If it's not good or rotted it will make a dull thud sound.
@WayneTheBoatGuy
@WayneTheBoatGuy 4 жыл бұрын
Neat idea! I am going to try your technique at the end of the season. I imagine I'll get a little of both on my transom!
@Paidtimeoff47
@Paidtimeoff47 4 жыл бұрын
Trust me it works...boat builders have been using that technique for years in or to find rot in a transom
@anunentitledmotivatedmille7731
@anunentitledmotivatedmille7731 3 жыл бұрын
Thanks
@brianhennig6931
@brianhennig6931 4 ай бұрын
Love watching your content. Subscribed right away. You have talked about seat mounts and your new wooden skiff project looks great but i havent seen anything about transom savers/totes(transit supprts). I know you dont trailer far and now are mostly small engine, but you do your research and through your boating journey have learned alot. I, being new to the boat owner world would appriciate your input. Could a saver maybe help prevent this kind of rotted transom? I just got a new to me trihull and youtube and your content has been helpfull in bring it back to life
@pjbrawn2646
@pjbrawn2646 Жыл бұрын
If you have a small 1 inch crack above transom where is it worth worrying about?
@jasonbroyhill2029
@jasonbroyhill2029 Жыл бұрын
How did everything turn out? Did you end up having to replace or is it still going string ?
@WayneTheBoatGuy
@WayneTheBoatGuy Жыл бұрын
It got me through another season and I disclosed EVERYTHING to the next owner, but they only used it once, and ultimately sold it and I have no idea where the boat is now.
@Newfie-iv5pe
@Newfie-iv5pe 4 жыл бұрын
You are going to have to replace the transom. I replaced one 3 years ago on my dads fishing boat. His transom had the same gap as yours. It was from water getting in the wood and swelling it out. On my dad's boat it had marine putty around the top edge instead of aluminum like yours but when it got wet and swelled it broke it all lose. I also replaced the one on my boat 2 weeks ago. I just used 2x10 with threaded rods to keep them tight together. Not a real big job. No trouble to do it in a day.
@WayneTheBoatGuy
@WayneTheBoatGuy 4 жыл бұрын
Yeah I agree - and I will feel much better knowing there's a new transom on there! Thanks for watching!!!
@steveellis6090
@steveellis6090 4 жыл бұрын
@@WayneTheBoatGuy I just repaired mine with Coosa board, , It's expensive, but worth it in the long run, that's if you intend to keep the boat a long time.
@kevinh6918
@kevinh6918 4 жыл бұрын
Dark and damp = Bad. Any wood in contact with wet wood will dry rot. I'm in the middle of a complete rebuild on a VIP Baystealth, literally every piece of wood on the boat was dust or soggy.
@WayneTheBoatGuy
@WayneTheBoatGuy 4 жыл бұрын
Yeah it just works it’s way through once it gets going.
@kevinh6918
@kevinh6918 4 жыл бұрын
@@WayneTheBoatGuy Thanks for posting the videos and sharing !
@CptAJbanned
@CptAJbanned 4 жыл бұрын
Stand on the engine and jump. A little nudge is not enough. Its a 150kg, 90hp engine on the back of a boat that is going to jump through the air at 30-40 mph and land flat on the water with a vengeance. The transom should take a good beating, jump on the motor a little bit and it shouldnt flex.
@WayneTheBoatGuy
@WayneTheBoatGuy 4 жыл бұрын
I would think that an additional 200 lbs. (92 Kg) of weight jumping on an engine would definitely break something that I don't want broken! A knowledgeable friend and I pushed and pulled pretty hard on the engine and moved the whole boat but the transom didn't budge. At the moment I trust it for the 20 or so more rides we plan to take this summer. But I am checking it regularly as well.
@CptAJbanned
@CptAJbanned 4 жыл бұрын
@@WayneTheBoatGuy It will take it just fine. Imagine the torque it handles when the boat jumps. Its much more than an extra 90kg. But you're probably alright, it looks fine. Just saying, that is a surefire way to test, done it tons of times, heck thats that way I get up on the boat, by stepping on the engine.
@jakenefsey9228
@jakenefsey9228 8 ай бұрын
​@@CptAJbannedwhat about an extra 350 pounds
@thedrummersclub3667
@thedrummersclub3667 3 жыл бұрын
Educational, Thank you
@winstonrocco1981
@winstonrocco1981 2 жыл бұрын
A dead blow hammer tap the transom if you hear a thud it’s bad
@johnwinnerdz1
@johnwinnerdz1 4 жыл бұрын
Can't test motor now because transom is damaged by ramp driver.
@johnwinnerdz1
@johnwinnerdz1 4 жыл бұрын
Can't sell boat cause the transom damaged .waaaah lol
@WayneTheBoatGuy
@WayneTheBoatGuy 4 жыл бұрын
Hopefully it's repairable!
@anunentitledmotivatedmille7731
@anunentitledmotivatedmille7731 3 жыл бұрын
@@johnwinnerdz1 these are all problems that will not get fixed focusing on how you cannot. I bet you probably are capable of more then you think.
@ahmedahmed-ul7gr
@ahmedahmed-ul7gr Жыл бұрын
Lol why did I watch this again
@WayneTheBoatGuy
@WayneTheBoatGuy 4 жыл бұрын
Is the gap between the back and top of my transom normal? Do you have some good advice or a similar experience? Let me know in the comments! I ended up fabricating a new and much better transom cap for the boat which should get me through the season. Watch it here: kzbin.info/www/bejne/g6fIpoKMp8qbq5o
@frank-lt3tp
@frank-lt3tp 7 ай бұрын
Wayne the boat guy doesn't know about transoms?
@WayneTheBoatGuy
@WayneTheBoatGuy 7 ай бұрын
That is correct. I only started boating a few years ago, I'm no expert - I'm learning as I go.
@frank-lt3tp
@frank-lt3tp 7 ай бұрын
@@WayneTheBoatGuy Ok so you're Wayne the learning about boats guy. I like it. Enjoy the journey brother.
@stunnin420ify
@stunnin420ify 3 жыл бұрын
Kermit the frog is that you
@TheDartsPirate
@TheDartsPirate 3 жыл бұрын
Your transom is Shot, cut it out and redo the whole thing
@WayneTheBoatGuy
@WayneTheBoatGuy 3 жыл бұрын
It made it though the season!
@jordanbeyer7607
@jordanbeyer7607 4 жыл бұрын
That gap is not normal. It sould be sealed up. And not with a piece of aluminum but glasses in properly. Deffinetly someone had there fingers in it Jusy by looking at the wood it looks like it is likely rotted. Stand on the cavitation plate of the engine and bounce. It should have no flex. It may be good for a a season or two. Just depends. But how much trust do you put in it knowing it is structurally flawed. Using epoxy resin, thayll be about a 600 dollar job. 225 for wood, 150 for epoxy. And the rest in fiberglass, gel coat, supply's and other nessisarys
@WayneTheBoatGuy
@WayneTheBoatGuy 4 жыл бұрын
Yeah I was thinking it might be do-able for under $1,000. Really thinking it’s going to be a fall project if I am keeping the boat after this season.
@anunentitledmotivatedmille7731
@anunentitledmotivatedmille7731 3 жыл бұрын
One year later the same lumber cost 5 times as much.
@kuffinmoore5621
@kuffinmoore5621 2 жыл бұрын
That does not look good buddy.
@WayneTheBoatGuy
@WayneTheBoatGuy 2 жыл бұрын
It wasn't! lol
@taylerellis378
@taylerellis378 3 жыл бұрын
That transom is shot
@WayneTheBoatGuy
@WayneTheBoatGuy 3 жыл бұрын
It did get me through another season though!
@anunentitledmotivatedmille7731
@anunentitledmotivatedmille7731 3 жыл бұрын
Mine is insanely flexible.
Replacing A Boat Transom | Boat Restoration Project!
47:00
Perfect Fit Boating
Рет қаралды 141 М.
Fiberglassing A Composite Boat Transom! Start to Finish!
18:12
Born Again Boating
Рет қаралды 844 М.
How Strong Is Tape?
00:24
Stokes Twins
Рет қаралды 96 МЛН
coco在求救? #小丑 #天使 #shorts
00:29
好人小丑
Рет қаралды 120 МЛН
When you have a very capricious child 😂😘👍
00:16
Like Asiya
Рет қаралды 18 МЛН
Complete Transom Rebuild, Step by Step How-To!  Part 1
13:13
Pastoral Homestead Outdoors
Рет қаралды 142 М.
Boat Transom Replacement - Marine plywood, coosa board, or something else?
9:34
How to mix 2 stroke boat gas for your outboard
7:45
Wayne The Boat Guy
Рет қаралды 191 М.
Boat Trailer Guides - Easy Cheap DIY Homemade Guides!
19:01
Wayne The Boat Guy
Рет қаралды 108 М.
How to get your boat ready for bottom paint
6:34
Tips from a Shipwright
Рет қаралды 411 М.
Rep akterspegel Del 4
8:07
Claes Andersson
Рет қаралды 2,4 М.
The Easiest Way To Replace A Boat Transom
38:35
Go Midwest Fishing
Рет қаралды 711 М.
How To Fix Your Leaky Aluminum Boat
12:57
Wayne The Boat Guy
Рет қаралды 5 М.
IT'S REALY THAT EASY!!!!!  FINDING LEAKS AND REPLACING RIVETS IN ALUMINUM BOATS
9:21
85 grady white transom test for rot
1:29
peanutavalon
Рет қаралды 32 М.
How Strong Is Tape?
00:24
Stokes Twins
Рет қаралды 96 МЛН