JALTEST CASE STUDY | Adjustment of the wear sensor with WST in Knorr-Bremse SB7 brake caliper

Welcome to a new Jaltest Case Study! Today we tell you which actions to perform when the wear sensor of a Knorr-Bremse SB7 brake caliper, in this case a continuous sensor, shows an incorrect value.
With the portable device Jaltest WST (Wear Sensor Tester) of Jaltest Tools, our range of professional equipment for workshops, we are going to verify that the wear sensor reading is incorrect in relation to the distance between the brake pads. After that, we are going to adjust the sensor, check that it is correct and therefore not necessary to replace the component.
Get your Jaltest WST here! bit.ly/3EHAjMz.
Besides, discover the brake caliper and the wear sensor of Cojali Parts that appear in this video:
• Brake caliper: bit.ly/3syuf4e
• Wear sensor: bit.ly/3sttWry
If you did not see our video on how to perform checks with Jaltest WST on brake calipers Meritor ELSA 2 and Knorr-Bremse SB7 with end-of-pad/2-wire sensor, find it out now! • JALTEST CASE STUDY | C...
#JaltestTools #Jaltest #CojaliParts

[@nicolae3140]

Does anyone know a way of using a voltimeter to do the calibrations on the caliper?

[@jaltest]

Hello Nico, Jaltest WST is the quickest and easiest way to perform calibration.

[@nicolae3140]

@@jaltest i need cheapest way not the quickest

[@stu8538]

@@nicolae3140 if only one side is bad, remove the sensor plugs for calipers left and right, back the calipers all the way out, use your ohmmeter and measure resistance between calipers sensor pins. Adjust the calipers fully and measure again (if your pads aren’t new and rotors nearly identical in thickness remove pads) The sensor is just a potentiometer.