Jeti - M Vario introduction

[@mypanicbutton9194]

Thanks for the explanation of the Dead Zone...very helpful in maximizing the benefit of the vario

[@UKAviationMovies]

Great! Thanks Harry 👍

[@Atari-stfm]

Harry you can do the height and vario voice announcements from the single announcements menu and therefore have a different switch if required.

[@408jpr]

Hi Harry, I was wondering about you use of the dead zone and range. What about offsetting the range values including the center by -0.7 and then using the dead zone to cover the noise in the signal? Just a thought.

[@bogdanstefan5362]

Your videos are great ! I’ve been looking to program a smoke pump with my ds12 and you helped a lot. However, I’ve been searching for a tutorial on how to connect a Rex7 to a Powerbox ( I have the pioneer ) via ex-bus. I also want to connect the ignition switch and the smoke pump to this rx via normal channels. Would that be possible ?

[@cotswoldpilot]

I do not use Powerbox so I do not help with that. I think powerbox does not take Exbus, you use UDI. You can connect servos and devices to the receiver as well as having the Exbus/UDI connection to the powerbox but you must ensure that the receiver is given sufficient power supply to drive those servos and devices.

[@bogdanstefan5362]

@@cotswoldpilot well all I want to connect to it is a smoke pump that has an independent power supply and the rcxl ignitions that also has its own lipo. Powerbox takes Ex-bus, this is what is shown in the manual. Thank you and keep up the good work !

[@BennyWachtelaer]

👍