Jigseries Episode 3 - Compound radius routing jig

A little film to show my compound radius routing jig.

[@gilsolomon]

THIS IS AMAZING! By far the best compound radius idea I've seen.

[@fairguinevere666]

Wow! You're a genius. I've seen this mechanism suspended above a sanding belt in some guitar factory videos, and mechanisms where the router moves relative to the board, but this seems to be the best of all worlds for a small shop.

[@tippocta]

Great design! This would be super easy to manage different radii. Simply drill new pivots centered on the fret board. Love it.

[@mallninja9805]

Dude, that's wonderfully simple.

[@philipbyrnes7501]

Thank you for sharing this, that is very clever and quite ingenious for something so very simple to build and achieve. Very, very clever, thank you again.

[@numberkruncherr]

Very nicely built. The bench mounting is a good idea, especially for people who aren't going to be radiusing fretboards on a daily basis and so would rather spend a couple of minutes getting it out and setting it up than lose the floor space.

[@masinstrumentmakeri3790]

Yes it save a lot of floorspace, Thanks :-)

[@MrTomarkins]

Hi , great job , do yo keep the centre piece ,that rocks from side side perfectly flush on Top r a bit shy, thanks, tom

[@scajesback]

really great and straight forward jig, thank you so much for sharing

[@masinstrumentmakeri3790]

Thanks for watching my video 😀

[@sidneidossantos923]

Belo gabarito ! Inspirador !

[@RickFaris]

Are the pins at an angle? Or are they just drilled 90 degrees to the side?

[@Yosser70]

That’s a very nice jig but could I ask about the quick release that seems to be on your router? Looks like you just clipped it onto the jig, and that’d be very handy.

[@masinstrumentmakeri3790]

Thanks 😀 the quick release system is copying rings from Festool. I baught some extra for my jigs.

[@martymcfly002]

Very nice jig! I'm just wondering, how do you know which angle to drill for the pegs?

[@masinstrumentmakeri3790]

I made a full scale drawing on a paper and drill the holes on free hand. Thanks 😀

[@martymcfly002]

@@masinstrumentmakeri3790 Ok that makes sense thanks!

[@tommydale5911]

Jeg laget en lgnende jig for mange år siden, men den var ikke så solid og godt bygget som din! Jeg tror jeg kommer til å lage en jig som denne. Takk for inspirasjon! :)

[@masinstrumentmakeri3790]

Tack själv 😀

[@shawnclose5261]

How does one get plans for this jig?

[@masinstrumentmakeri3790]

Sorry I dont have plan for this jig. I made my jig from a simple drawing many years ago.

[@MarcDanielsMusic]

Do you have the plans of this jig :D?¿

[@masinstrumentmakeri3790]

No sorry, I made this jig many years ago from a simple sketch 😀