How to Roll Angle Iron Leg-In on a JMT Profile Roll

JMTUSA.com | Demonstration of how to roll angle iron "the hard way" (leg-in) on a JMT PBH80 angle roll. This is more difficult than rolling leg-out, as the material in the leg (flange) has to be compressed, rather than stretched. The operator shows the used of side support rolls in keeping the material from twisting and deforming during the rolling process. JMT angle rolls and other JMT metal fabricating machines are sold nationwide by JMT distributors (jmtusa.com/find.... Call JMT toll-free at 855-773-7727 or email [e-mail].

[@papocruz1295]

Start again with a new piece, that’s scrap bro

[@theloniousm4337]

Not a good video for showing the machines capabilities when the person may not have ever bent angle iron leg-in before. Maybe practice off camera first.

[@southafricanchap]

what was the point f this video. He didnt even get it straight!!!

[@shanebryant789]

This is how not to do it!!😅

[@tiennguyensi4776]

Perhaps This angle bend by equipment frequency for more good.

[@tonymackey370]

Typical leg in angle roll . It makes you pull your hair out . Try tacking two angles back to back it helps control twist

[@jasintodorado8145]

Thanks for you video. I realy like.

[@விவசாயம்இளையதலைமுறை]

Price sir