John Deere 5075E Running Rough / Surging - Replacing Both Fuel Filters - Let's Figure This Out

[@billybobs841]

Good video bud thanks

[@BigBucks191]

Thanks for the video!! I was finally able to fix my tractor.

[@ecrews2]

Thanks for taking the time to make this video

[@LetsFigureThisOut]

You're welcome

[@stanfirstov3815]

thank you for this video, it helped to resolve the same issues I had with my 5055E

[@LetsFigureThisOut]

In addition to cleaning the filters, I've started adding Kill-Em Oil & Biodiesel Anti-bacterial Treatment.

[@1squirreldog]

Thank you for the video it was very helpful.

[@mikehughesworkingdog]

same problem, same tractor. thnks from New Zealand

[@donshields4470]

My filter ring was TIGHT! Had to use large channel locks. The plastic threads on this ring are kinda crude...it is a little hard to remove and install.

[@LetsFigureThisOut]

Put a bit of anti-seize on the threads

[@billybobs841]

I think it hard to push the filter up in it

[@longnooyen]

Great video! Thank you

[@josephvallinvillasenor2698]

Great video. Thanks for making it.

[@billybobs841]

You had any problems with the plastic hydraulic filter housen leaken

[@LetsFigureThisOut]

@@billybobs841 the only leaks I've had are coolant leaks. Took a while but I managed to get them all stopped.

[@byronmarquart6608]

I took mine out and cleaned it two years ago. Now I'm doing it again, Does that sound about right?

[@LetsFigureThisOut]

It depends on your fuel source and how long it sets unused. I try to run the fuel level down below 1/4 tank then I fill it up. Every time I fill I treat the fuel with (Kill Em) which is a diesel fuel biocide which will kill the stuff that grows in diesel.. So far so good

[@byronmarquart6608]

Thanks. I’ll look into getting some

[@byronmarquart6608]

Ended up getting something at John Deere. A little safer than kill ‘em. Mix one ounce per 10 gallons. Getting too old to keep laying under my tractor.

[@lastpatriot2129]

Mine got cut off an thrown in the woods today

[@LetsFigureThisOut]

Usually after I do that I wind up trying to find the part I "stored outside"

[@tracyhastings2941]

Great job