John Deere DASH REMOVAL DASH CLUSTER 4wd dash light DIY MOD DASH 1025R part 2

[@joerubi03]

Great write up, I just finished the install on my 2025r,which is similar to the 1025R but…. The 2025R, although it’s very very similar to the 1025R, has a fender brace bar that runs directly under the place where the switch would be mounted on the 1025R. I had to fab up a mount using a 1” piece of square tube that I fed thru the bar and mounted it to the base, then mounted the switch to the bottom of the square tube. Took me longer than it normally would take but doable if you want it. And I had to buy one of the “Jesus” clips from the dealer because my tractor ate one of them somewhere in the frame😀 Thanks for the write up👍

[@GMGJDMOD]

U bet

[@GMGJDMOD]

Glad it was helpful for you Also glad you could utilize On your rig. I’m sure if you had to do it again it would take half the time . First time always takes the longest.

[@jimkwader6956]

Excellent video, Thanks!

[@fsj197811]

Cool deal, thanks for sharing.

[@GMGJDMOD]

You bet

[@adamd4218]

Heeyy.. I found this on youtube ;)

[@DavidTaylor24]

The tip about removing the side panel to get at the rods was worth $1,000,000! It's a bear without that information.

[@GMGJDMOD]

Good I take Venmo Lol