JP CNC ALL METAL HIGH END QUALITY 120mm EDF 12S Testing video 1

JP High performance EDF.
Totally weight is 695g of JP 120mm EDF at 12S.
Recommended ESC: HV 150A or JP HV 150A
All the EDF are adopting advanced aluminum alloy and made by High precision CNC machines.
Each blades and motor are have advanced Balance. Running very smooth,you don't need to do any balance again.

[@bobadingo]

The only thrust number to look for here is the 3.7 Volt per cell rating! Unless you're using high-voltage lipos.. .

[@chebertjr]

Shane I wish you would do the same test away from the wall, I have tested Edfs against and away from a wall and it does make a difference in numbers.

[@shaneyang3869]

Hi Clarence. The wall always 2 meter from the testing stand. The difference numbers is depend on your battery. Here is the video link for you to check with battery testing. kzbin.info/www/bejne/nmHdk3h7gdSkodk

[@chebertjr]

Shane Yang Shane I've been in RC for over 30 years, the video I watched had the wall right behind the table.

[@chebertjr]

The wall is against the table in this video.

[@shaneyang3869]

I don't know how to put the pictures at here. I send to your mail. The wall is 2 meter far from test stand. JP fan has high thrust is not base on that wall.

[@shaneyang3869]

From the video or pictures some time you always bigger than a building.

[@tobilobasam]

What battery did you use for the 50.4v test?

[@nicov.2151]

I see you use a power converter instead of real Lipo batteries... I have not seen lipo's with 4.2 volts per cell.... why do you test 50,4 Volts? as it is not available during flight....or i really need a long extension cord

[@bobadingo]

So they can generate fabricated & falsified specifications!!.. .

[@nohtal]

How did you connect this to a/c power?

[@fuga3500gtfour]

GOOD