Juniper SRX Clustering Implementation | Control Link | Fabric Link | Reth Interfaces | RDG || Eve-ng

[@sridharbvnl2101]

nice video no extra on switch like adding VLAN config for wan,lan,mgmt interface from SRX's ?

[@kingsleyomons]

Yes, you should create vlans to separate the traffics /broadcast domain. All ports are access ports.

[@sridharbvnl2101]

thanks, those config's are shown in different videos? i am looking for the piece config and to understand whole picture/lab

[@kingsleyomons]

@@sridharbvnl2101 Yes, check this lab setup video. kzbin.info/www/bejne/b3exc5KVpr6Jm80&ab_channel=NetDevopsWorld.

[@sridharbvnl2101]

Thanks alot for your kind reply but for some reason, kzbin.info/www/bejne/b3exc5KVpr6Jm80&ab_channel=NetDevopsWorld this link is not opening is it open to access for all ? or you can share video title, i can search that video ;)

[@kevins6886]

All ports are access ports can be done in Cisco Switch ?

[@kevins6886]

can we use Cisco switch ?

[@kingsleyomons]

Yes, any layer2 device works

[@kevins6886]

thanks

[@Lee-qp2et]

on your diagram it's 0/0/4 is reth 1 not 0/0/3. Would be good if you stuck to the diagram so not to bring confusion

[@kingsleyomons]

Sorry for the mixup. It could be EVE-NG problem as physical interfaces connected does not translate to what you see on the CLI.