How To Laser Engrave a Cutting Board - xTool M1

[@djr3008]

Just an FYI. You helped me so I will help you as well. When you want to brake down your text to more then one line just put the cursor where you want to split the lines and hit enter. No backspace or shift key needed. (Copy paste), highlight object then right click on the object, hit copy then hit paste close to where you want it move to then make your adjustments. No need for c-control or v- control. You can also go to shapes to get a circle or square.

[@arizonaheatwave4080]

Another fantastic video!! I can’t thank you enough for the precise step by step tutorial, I struggle with computer stuff and I have learned an invaluable amount of info by just watching 2 of your videos! Thank you so much!! 😁

[@PoppyHillDesigns]

Great to hear!

[@TheScrapGranny]

You did a great job explaining each step. I just ordered the XTool M1 last night. This is exactly the tutorial I needed! Thank you!

[@PoppyHillDesigns]

Thank you, I'm glad you enjoyed the video.

[@buddysmith7080]

Thank you for the very detailed instructions. How did you know what to adjust the settings to?

[@PoppyHillDesigns]

I tested on another bit of wood to get the settings that I wanted. xTool has a newer version of their software out that gives you a visual of the settings, that will be helpful.

[@stephaniearchuleta9687]

Do u spray anything on them when they are done

[@PoppyHillDesigns]

You can apply food grade linseed oil.

[@viridianaflores3313]

What do you use so the wood won't moved ?thank you

[@PoppyHillDesigns]

Nothing, it's heavy enough so it won't move.

[@gambo47]

please help, I have a 20mm thick piece of oak but cannot find anywhere any help for what settings to use when using the honeycomb bed, which shelf if any I should be putting the oak board on, and then which settings I ned to change on the software before processing it... thanks

[@PoppyHillDesigns]

Remove the honeycomb and place it in the first slot down. Place the board on it and see if the top of the wood comes up to the opening, if not you will have to place something under it to make it level with the opening. Change the "MODE" to "Baseplate Removed" and perform the automeasure. If that comes back OK choose your settings from the materials panel. Use the new materials suggestions to choose the look you want.

[@gambo47]

Thankyou for that, I'm. Amazed that having watched so many videos, read loads of guides I couldn't find any that describes exactly what I was looking for. ​@@PoppyHillDesigns