Normally, this is very easy. If you pull the knob off you'll see the threaded shaft and locknut. Unscrew it and slide the circuit board out. Then all you need to do is drill a 1/4 inch hole and you can slide the shaft through and then tighten it with the nut. If the mounting plastic is really thick you can shorten the kicker knob by grinding a little bit of material off the bottom. You can also swap out the knob for whatever you want such as a custom aluminum unit.
@johnford836910 ай бұрын
Thats slick man. Btw what kind of front seats do you have in the rig?
@jmedlife7410 ай бұрын
These are Chevy SSR seats. Not a bolt in application.
@sikk84mcss8 ай бұрын
dam,watchin this hurts.knowing how hard it is to come by that piece in good condition.but i did get ideas,i would've done it where alarm bulb is,relocate bulb.(if u used it at all) i have same console in my tahoe.
@jmedlife748 ай бұрын
IKR. Bulb not used.
@sikk84mcss8 ай бұрын
@@jmedlife74 i gutted my console also.added en eq where cd player inside the arm rest once was.now,after seeing this.ill have to measure stuff out and see if i can fit both my amps also.all to stock raido with bluetooth.