KILN BEARING SCRAPPING | KHD KILN | Kiln Support roller Assembly | White Bronze Bearing.

#kiln #Kilnsupportroller #rotarykiln #cementplant #kilnrollingbearings
The Support Rollers (Material cast steel of Cr Mo type, heat treatable for air quenching and tempering like GS 42 Cr Mo 4 ) are in most cases made of cast steel shrunk-on to finished machined shafts (Material: special carbon steel for large forgings like CK35 or through hardened steel like 34 Cr Ni Mo6).
The roller profiles are either of the chamber type or anvil massive type with bored two to three holes for handling.
The liners are made of Aluminium-Zinc, with 32 % Al, 5 % Cu, and the balance Zn. This material is called “White Bronze” and has a bigger hardness, It has higher loads carrying capacity and wear resistance.
Force lubrication system & Hydrodynamic lubrication system make an oil film layer on the shaft. A separate water cooling system is applied for Oil & Bearing cooling purposes.

[@PushparajChauhan-tv6qb]

Nice video for mechanical fitter

[@LifeRoutewithRK]

ok

[@sangramchatterjee8607]

Very good & informative video. Please post more such videos.

[@LifeRoutewithRK]

Sure brother

[@rajkumarchauhan6360]

Very learning video good work

[@LifeRoutewithRK]

Thank you 🤗

[@aab.venkat]

Thanks for the Video Sir ❤❤❤

[@LifeRoutewithRK]

mmmmmm

[@haythemjabari54]

🎉🎉🎉🎉

[@LifeRoutewithRK]

mmmm

[@pankajsingh-sc4ye]

Very nice vedio sir ❤

[@LifeRoutewithRK]

Thanks and welcome

[@suniljain5532]

Very nice sir

[@LifeRoutewithRK]

Thanks and welcome

[@dipakvadgama6569]

Sir we are white metal bearing lining and machining As per requirement

[@LifeRoutewithRK]

Normally machining is not required Bearing will be delivered with machining face. We need only roller shafts matching with respective bearings

[@rixi1234]

Sir what is the cretria that how much area of bearing should be in contact with shaft

[@LifeRoutewithRK]

Its depends for This case these is marked area given in KHD manual. For fls only centre portion with 20 to 30 percentage

[@rixi1234]

@@LifeRoutewithRK is it 20 to 30% shaft diameter or circumference of shaft?

[@user-kr9rg7fz2x]

Wé have problems effective hait temperature but wy the raisant

[@LifeRoutewithRK]

Did not understand u r question

[@tripathynihar12]

Sir how much hours take to replace the bearing?

[@LifeRoutewithRK]

One bearing we meed 3 to 4 days

[@k.p.pranav7356]

Can u share some pdf abt the project..

[@LifeRoutewithRK]

You can contact me personally for any doubts

[@kishanrajyaguru8590]

Sir how to contact you

[@LifeRoutewithRK]

Email me [e-mail]

[@RamkumarYadav-wh9yr]

Very nice sir

[@LifeRoutewithRK]

Keep watching