Never ends with a boat. Good thing your handy! Imagine how much $$$ to have a shop keep up with her... Great vid!
@erniefollis78274 ай бұрын
I’m experiencing the same start up problems where it runs rough (I was thinking a bad plug), smokes and sputters but in 10 - 30 seconds runs fine. Lately it’s been doing the same every few minutes for about 10 seconds, then returning to normal. At 3:50 on the video you speak about disassembling the electric choke and adding a capful of oil in an access hole and working the assembly to get rid of the “crunchiness” - my question is the location of the access hole - is it on top of the black cap or do you have to disassemble the electric choke to find the hole.
@fairwindsii Жыл бұрын
Have a 5ECD low emission gen. 2009 Rinker. Need to pull the low P. fuel pump. Have you pulled it yet?
@stanportclintonOh2 ай бұрын
I have the same problem where is that hole???
@andreasward4764 Жыл бұрын
My flywheel is locked up... it's sat for a few years. How do I unlock it
@cme4brain113 жыл бұрын
Man, that hatch lift ram could not be in a worse location to service the generator
@fernandovillarruel73962 жыл бұрын
Mine didn’t turn on yesterday, what do think could be?
@fitzsfixes2 жыл бұрын
Check oil and coolant. If either are slightly low, it either won't start, or only run for a few min before shutting off
@tonytran42343 жыл бұрын
Hi Fitz, do you have instruction on how to replace low pressure fuel pump on 5ecd Kohler generator? I was told by the mechanic. I could not find part or video online? thanks
@fitzsfixes3 жыл бұрын
No I'm sorry, I don't. If I come up with anything, I'll be sure to comment on this post
@billflying29776 жыл бұрын
I believe I have a air lock. Runs until it gets hot and shuts down. I don't see a vent screw on yours opposite of the coolant cap.
@fitzsfixes6 жыл бұрын
Bill Flying no, I don't think there is one. I'll have to check. Is your thermostat opening? All the way? Is your heat exchanger plugged with rubber from an old impeller?
@OllieCards995 жыл бұрын
I’m having issues with my 5ECD. It’s giving fault code HE. I already changed impeller, added antifreeze, removed thermostat...
@troyp8252 жыл бұрын
My generator runs only when I hold the start button from control board. Any way to diag this problem?
@chadjennings57342 жыл бұрын
Same with my 5E! It will start and run as long as I hold down either start button and dies as soon as I let go of the button. I'm going to check for low oil and fuses. Hoping that it's not a voltage regulator, but that's what the internet is telling me.
@Supanova703 жыл бұрын
Question mine starts then stalls cant seem to keep running. any ideas?
@fitzsfixes3 жыл бұрын
Check oil level, and antifreeze level. If they're not perfect, the generator will only run for 5min then stop
@Supanova703 жыл бұрын
@@fitzsfixes ok this one start stops right away.i will check it out ty