Konica Minolta C224 Fuser Unit Rebuild Instructions

[@DAEMANCOMPANY]

i liked your work. excellent

[@MrRicoh]

Thank You :)

[@CrishianDuque]

Hello dear teacher. Is there a video where you explain how to convert a 224 fuser to 554

[@MrRicoh]

I don't have a movie like that because there's no way to convert it.

[@JamesMoore-un3cu]

I don't know why the Upper (sleeve) was not replaced as well? That's a standard thing to do if you want to repair this unit properly.

[@MrRicoh]

Yes you are right. The full replacement procedure is in another video. In this video I wanted to show only the bearing problem. Thank you for your opinion. Do you repair copiers? You know a lot, that's why I'm asking.

[@JamesMoore-un3cu]

@@MrRicoh Yrs, that's what I do for a living. 43 years this year...

[@rogerdarkman157]

It's a god think, but you change the pressure roller too, because the roller surface is deformating after many times.

[@MrRicoh]

I'm replacing the lower press roller because the bearing damaged its metal shaft

[@jeffpescinski8374]

Does anyone make the roller that puts pressure on the film? I have 454e fusers that the bearing damaged the shafts on that roller

[@monstermirror2]

lol, haven't seen a bearing completely dissolve like that. Wonder where all the balls went in the machine...

[@MrRicoh]

@monstermirror2 I decided to show it because I haven't seen it before. Of course, the bearings are not the best, but you don't see a failure like this every day. You're right, balls, they are found in various places in the machine to this day. Drama. Regards, my friend.