Kremlin Airmix Set Up # 105

[@bcroft68bc]

When painting Residential Cabinets, this is the best setup. I painted cabinets for three years with the Kremlin pump and Xcite gun. We had hoses for different colors of paint. When spraying Sealer and Lacquer, we had a pump and gun for each of them. Expensive but awesome equipment.

[@stevob390]

Our shop has 2 Kremlin MX guns. Using ML Campbell magnamax finishes. As the lead sprayer. I am very disappointed in the volume control and fan adjustments. Both have been rebuilt, but have operated the same, before and after. Having tried a C.A. Technologies pump spray unit. We're switching.

[@rotarycomptech]

Do you leave the product in the hose all the time...Is that why the gun heads are submerged in solvent or water?

[@123markh]

hey Scott,nice production set up, do you thin the precat? fisheye or retarder?, I am spraying some now and there is always a small amount of orange peel when viewed at a angle, it seems to tack up before leveling like glass. Any ideas? (spraying with a pressure pot, with plenty of atomizing air)

[@1030NW31st]

Hi Scott, I was watching your video comparing the G15 and the Kremlin gun, comments are disabled. I have a Graco Ultra 395 airless pump and was thinking of trying to run it aa. Can I ask questions about it here? Thanks, Bill

[@tammypeppers4869]

thanks a lot ....I am from North Carolina.

[@TheWoodCraftsman]

Not a proplem. I'd try High Point Pneumatics. I've also delt with Seneca Industrial in Iowa. Good luck. Scott.

[@justpaintitright6442]

bro i found a kremlin 10:1 pump and gun for $1000 ,,,,thats a good buy right ?

[@TheWoodCraftsman]

Yes, providing it works and doesn't need a bunch of parts. Typically the throat seal is the most common failure ($100). If the throat cup fills up with the product you are spraying over time, the throat seal will need to be replaced, and depending on the condition of the rod, it may need to be replaced to ($150). Good luck. Scott

[@stopthephilosophicalzombie9017]

Does anyone rent this type of equipment? I'm doing a restoration project but won't need it forever.

[@justpaintitright6442]

you got 2 wow lucky i wish i had one ,,,anyone in Philly we can split one 1500 each

[@TheWoodCraftsman]

Watch for them on eBay. You may have to put a few dollars in it, but usually worth it. I also have CA Technologies 14:1 Bobcat, it's a great alternative at a lower cost. Thanks. Scott

[@tammypeppers4869]

where can I get parts for the mvx?

[@TheWoodCraftsman]

+Tammy Peppers Hi, Depending on your location in the US, there are several distributors. Grapek Action (PA), Seneca Industrial (IA), High Point Pneumatics (NC), and Annex Paints (AZ. Thanks! Scott

[@stopthephilosophicalzombie9017]

You're a good son. ; )