KTM 1290 - Steering damper oil change

Рет қаралды 9,713

Жыл бұрын

Пікірлер: 28

@nickkline9874 6 күн бұрын

Thanks for this video - others are good but this one is the easiest, most efficient method of replacing the oil. Thank you! FYI - I swapped the oil on my 2023SAR with stock tires, still new bike (1.5k miles). I can feel the improvement at low & moderate speeds, but under hard acceleration over 100mph the shake comes back. New tires would probably solve it, so would more viscous oil. For what I need though, this is perfect so thank you Czerp for the great tutorial.

@link7373 Жыл бұрын

Thanks for this. I followed your instructions and replaced mine with 10W oil in about 30 minutes. This video really helped!

@arturrafa6609 Ай бұрын

Wielkie dzięki za nagranie pomocnego materiału. Wlałem olej do amorów 15W a jak nie ustanie shimmy to wleję hipol 80w90

@Cr3atureOfNature 8 ай бұрын

This video was of great help, thank you very much! 🙌 I used Motul 20W Heavy and I'm impressed by the results.

@Whaijian Ай бұрын

Thanks for good video!I am repairing my steering damper

@sanjuthapattanapiromkul8543 3 ай бұрын

Thank you for the good knowledge.❤

@lifetimeangler 7 ай бұрын

Did it improve it

@rafapiatek1578 Жыл бұрын

Wiesz może jak zdiagnozować łożysko glówki ramy? mam zdjęte wlaśnie lagi bo poszły do naprawy uszczelnienia i jak ruszam kierownica swobodnie góra dół to ma luz ale nie wiem czy to dlatego że nie ma lag czy dlatego że jest uszkodzone łózysko

@noorfazlin6559 4 ай бұрын

Is it cause leak sometimes cause mine leaked a little after changed the oil. Not so major just a minor leak happened 😅

@bartomiejpiekarz9678 Жыл бұрын

Czekam na testy po wymianie oleju.... Pozdrowienia

@AKAOmnivore 3 ай бұрын

I did this with 20w and it helped the decel high speed tank slapper wobble quite a bit but not completely, that said its the actual design of the connector that is the problem, the center piston has a single ring type fastener and it flexes up and down a bit which seems to me to be the actual problem (I'm only knowledgeable on the 2016-7 GT)

@mikekeuben 2 ай бұрын

I want to do this with my steering damper too. Could you maybe tell me wich oil you exactly used?

@AKAOmnivore 2 ай бұрын

@@mikekeuben It kept on deleting my link to what I used soooo. Maxima V-Twin Fork Oil 20wt

@mikekeuben 2 ай бұрын

@@AKAOmnivore no worries, thankyou for the reply

@aveewenement4098 12 күн бұрын

Kolego skąd jesteś potrzebuje to ogarnąć

@EstebanAGaido 5 ай бұрын

I´m just following this steps. Thank you! The only doubt I have... is if the seal is compromised after hammering for expelling the unlocked seal... because the "head" is entering in that seal... this is not going to cause a leak later? By the way, are you happy with 15W or do you feel like it will be better to put 20W? Thanks!

@czerpzzycia539 4 ай бұрын

In my opinion it shouldn't damage the seal I have also checked it, if I will see any leaks - I will find new seal and replace it. I have used 15W because I want to have easy "work" at terrain, also I equipped additional scott steering damper

@EstebanAGaido 4 ай бұрын

@@czerpzzycia539 I did the mod that same day. No problem with seals leaking and the steering improved the feeling! I think maybe a 20W will be even better. But of course an adjustable one is the way to go. Thank you so much!!