A little explanation of hydraulics and how they're set up on Kubota tractors
Пікірлер: 27
@LetsRogerThat5 ай бұрын
Your video provides a lot of great information. Thank you.
@donaldstrishock39232 жыл бұрын
A GREAT review & congratulations on HAVING a gear drive tractor. I am almost ready to put a PTO hydraulic pump on the back-hoe ( a BH92 on a MX5200) supped up the flow 40% by changing to bigger hydraulic lines&fittings on the loader control to the hydraulic block. No more power but l can use all 4 BACKHOE circuits at once instead of just 2&1/2 from the stock's wimpy lines &fittings. Thanks for the great vidio Sir and happy safe Tractoring.
@NoNonsenseKnowHow4 жыл бұрын
Thanks for the great information!
@pthomasrandall487310 жыл бұрын
Thanks for the info! I've been looking for hydraulics explanations and yours is the best I've seen. L3400 information is hard to come by. I have a leak between the main valve and the pump and you highlighted that area so I think I can fix it now.
@lost941337 жыл бұрын
if you buy a kubota HST do not use anything but kubota hydro oil no matter what anyone tells you .I've run kubota tractor's for 20 yrs every day not one problem They're the very best as far as I'm concerned
@aa-hw5bh7 жыл бұрын
I have a L3600 when it gets warm it don't want to pull like it's week steering don't want to work eitheris it a hydraulic pump or does anyone know
@kimberlypaddie4 жыл бұрын
This was a lot of help. Thanks
@donaldpedigo2968 жыл бұрын
You're a Good Man to share all of this information......I am considering buying a compact, or a utility tractor, and I will make sure that I buy the Workshop Manual for whichever tractor I end up with.....One question, is the Backhoe on this L3400 sufficient to perform the digging, trenching, etc.....that you need for your company...?.........One more question, do you like the Constant Mesh Transmission, or would you prefer to have a Hydrostatic Transmission...?
@TanyaPapp5 жыл бұрын
Is that a super big cat in the video in front of your tractor?
@json77286 жыл бұрын
Great video. What sub frame mount did you buy to mount a 3375 Bradco to your L3400? I can't find any help on this combo. I appreciate any contact info. J
@tuckswanger3 жыл бұрын
Does this effectthe transmission too
@eecyajgonohad92234 жыл бұрын
Hey i have a problem about or unit l3608 its triller is not functioning we check the hydraulic if its broken but its workint very well we're all out of option we tried everything . Can you help me?
@als4843 жыл бұрын
Great video is there anyway you can send me a picture of page @2:30 in video
@mohamedhegazy1465 жыл бұрын
How are you vedio good.. I want catalog tractor koubuta L1_225 how find
@railroader0101716 жыл бұрын
I have a B8200 tractor. The rear lift lifts fine but it is very slow going down even with implements on it. What do I need to check?
@thomascrawford99096 жыл бұрын
There should be an adjustment between your ankles. A round knob, with arrows going left and right. This is your" rate of descent adjustment for 3 point hitch". Depending on how heavy you have an implement on your 3ph or how fast it drops. Adjust to your needs. READ OWNERS MANUAL. It is there
@guybailey35307 жыл бұрын
We have a kubota L245 DT tractor how do you know when the hydraulic fluid is full.
@urbancowboy09147 жыл бұрын
Fill until about half of the shaft is covered. That's how I run mine. (same exact model)
@markfitzpatrick45436 жыл бұрын
Is that with the motor running or not running,
@danh62243 жыл бұрын
Thanks for the info. Fyi.. If you have the ability to edit video (most computers have basic editors), I would redo those sections where your pointing to hoses, etc. but the camera angle is off and your unable to see which area of the hydraulic block your pointing to.
@andrewlabat99637 жыл бұрын
👍🏼
@MiguelSanchez-pf6pd4 жыл бұрын
I have a LA 525 backhoe parts no hydraulic pressure
@emmettmcelwain72642 жыл бұрын
Rambles too much doesn't stay on topic you forget what you was looking for by the time he gets done rambling on about everything else