L293d Motor Shield Soldering RXD And TXD Pin || Motor Shield Drill Pin Hole

(1) TxD pin is set for output when the serial I/O enable bit is "1" and the transmit enable bit is "1", regardless of the port direction register setting. (2) RxD pin is set for input when the serial I/O enable bit is "1" and the receive enable bit is "1", regardless of the port direction register setting.
Using this L293D motor driver IC is very simple. The IC works on the principle of Half H-Bridge, let us not go too deep into what H-Bridge means, but for now just know that H bridge is a set up which is used to run motors both in clock wise and anti clockwise direction. As said earlier this IC is capable of running two motors at the any direction at the same time, the circuit to achieve the same is shown below.
ＬＩＫＥ | ＣＯＭＭＥＮＴ | ＳＨＡＲＥ | ＳＵＢＳＣＲＩＢＥ
=== = = = = = = = == = = = == = = = == = =
== = = = = == = = = = = = = == = = = = = ==
★★ Please like and subscribe ★★
/ @yellowpurple
=== = = = = = = = == = = = == = = = == = =
How to extend wifi range with another router wirelessly
• How to extend wifi ran...
Hack ip camera easy way
• Video
How to extend wifi range with another router
• How to Extend WiFi Ran...
★★=== = = = = = = = ==★★
Contact us for any enquiries :
[e-mail]
rubel1628
★★=== = = = = = = = ==★★
#yellowpurple
#RXDPIN
#TXDPIN
=== = = = = = = = == = = = == = = = == = =

[@YellowPurple]

*How To Make Arduino Obstacle Avoiding Car At Home || Smart Ultrasonic Sensor Car* kzbin.info/www/bejne/oJyXg32NfNCKi8U

[@abdallashalaby6087]

Thank you for this I really didn't know how to put this pins here, جزاك الله خيراً :)

[@YellowPurple]

*wc 🙂*

[@YasoHisham]

​@@YellowPurplecan I use all pins or certain pins only?

[@moawajunie9371]

What should we do if want to use other analog or digital pins while using a shield

[@GG-sd2dr]

What tool did you use to drill the holes?

[@YellowPurple]

Lx134MO Electric Mini Grinder

[@GG-sd2dr]

@@YellowPurple Thanks

[@GG-sd2dr]

@@YellowPurple Thanks!

[@tomasszapu660]

Can i plug the rx and tx pins into esp8266. I need it for serial communication.

[@FFGAMERZ1992]

Bro we can use Jumper wire pins instead

[@vanshjhawar4860]

Did you got the answer that whether can we use jumper wire pins?

[@FFGAMERZ1992]

@@vanshjhawar4860 no

[@94gbgaming_yt]

Bro from where you have taken the soldering pins

[@GTA_Fanatic]

They are header pins, easily available at electronics stores

[@derickstar]

thank you so much

[@harshthakur1759]

Where to buy these pins?

[@samyaksigdel]

name of the pins

[@ashmitsherigar3930]

Bergs