Lab 2.1.2.10- Building a Switched Network with Redundant Links - Demonstration CCNA 3 Chapter 2

[@hamzajamilahmadbegum9168]

Thank you So much.... You explained it very well. the way you explained and by showing with packet tracers tools e.g switches that was so good to understand. Thanks again.

[@thuydinh7426]

VERY WELL EXPLAIN AND DETAILS , I FELT LIKE I AM ACTUALLY DOING THE REAL LAB HERE.

[@nivekmozart6183]

this is the answer im talking about, it's all about the cost! dang it! thank you

[@nasirazizkwt1]

Thank you very much for guide line .

[@sesquipedalian77]

Instead of typing S1#show run interface0/3, just type S1#show run. Then you will be able to see that channel 1 is desirable. And thanks for the video and doc. :-)

[@Jomster777]

in my spanning-tree command: there is no cost command available after it. Why?

[@ankitchouhan2795]

How i can configure ring network by using link aggregation protocol without port block?? Plz suggest!!

[@AstritKrasniqi]

no there is no loop allowed, so one port will be blocked always, you can load balance but for every VLAN there will be one port that is in blocking mode.