How to cut and sew a Bustier with armhole princess darts.

[@princewillibiso5449]

@wearlala....Thank you for this tutorial, I've learnt alot from your tutorials and this is wonderful. I love your voice too. I hope you could teach how to make Neckline Bustier too.....

[@doofaniordyeh]

Thank you for this video

[@lauretvic7302]

I love your teaching

[@wearlala]

Thank you

[@aribibiaoba1194]

Thank You for this vedio.

[@temitopetaiwo8142]

The cup came out so well

[@shukuriyyah3724]

Thanks so much for this Plss can i use this method for princess dart blouse

[@blessingomoyoyovwi6849]

Thank you for sharing Lala You are the best ❤

[@oyebodegladys4256]

Thank you for sharing this, this is way more simpler than what I do, for the side dart you didn't cut it out on your fabric and I didn't notice any slant on the side, I will appreciate if you can show more light on it . Thanks

[@wearlala]

The bust dart is already closed on the pattern

[@a_biodun]

Thank you so much for your teaching. So how do i determine the bust curve if i want to make bustier for someone else. You said everyone can't use 2" at the waist and underbust. Thank you for your help. i anticipate your response please.

[@wearlala]

Watch the video again. You will use the person's waist and bust circumference measurement

[@FaithVictor-h9z]

❤❤

[@ChinnyNwankwogu-sx9rg]

Thank you ma. After sewing, i noticed my front bodice was short with about 2inches

[@jessicanteheleng6867]

Thank you very much for sharing God bless you. What happen if the difference between bust and waist is 4inch

[@wearlala]

It is the same process. The person must be busty with a small waist.

[@ugochiagbakwuru4526]

U dod not mark out d waist circumference before cutting out, u only marked d burst circumference

[@sweetteestv3150]

Can i cut directly on fabric

[@wearlala]

No

[@sweetteestv3150]

OK ma, thanks

[@ChidiBigfish]

What if the diff btw my bust and W is 0.75 and Bust and UB is 1.5

[@ugochiagbakwuru4526]

Tnk u ma'am,, but ma u dint mark out d waist circumference before cutting, u only marked d burst circumference

[@wearlala]

I guess you didnt watch the video completely