Clearing a GBC`s HeatSeal H312 jam-free series laminator. Disassembly steps shown.
Пікірлер: 17
@TheHumbleWiseMan6 жыл бұрын
I have a Purple Cows laminator, which I bought from Costco about 15 years ago for $20.00. Now they are about $200.00 online. It worked fine until today when something got jammed. I watched your video and was able to pull the piece and put the laminator back together. Very helpful video. Thank you!
@dougdornbos51736 жыл бұрын
THANK-YOU! Fixed a model H310 by following your video. I had to pry the aluminum top cover off to get at the roller but would have never got that far without your help. I appreciate it. Well done.
@theoverengineer6 жыл бұрын
Thanks for watching!
@mandyvanzyl99633 жыл бұрын
Great help. Managed to open my machine GBC 1200 and get the jammed pouches out. Thank you
@BodenSandGravel2 жыл бұрын
This gave me such a giggle, but it worked...now to put it back together!!
@Asli1717 Жыл бұрын
I love this man’s narration 😂 so unimpressed
@mlew2476 жыл бұрын
Thank you. Got that jam out with the help of this video.
@JimAllen-Persona9 ай бұрын
The 210 is different, sadly. I was able to take everything down but I can’t get the output guides on the motor side back in and sitting flush. That plus my cat jumped up on my desk and knocked that locking ring onto the carpet and I can’t find it. I think it’s maybe been used 5 times in 15 years and if I can’t get it back together it’s junk. It’s almost 3AM, I’m looking at it tomorrow with fresh eyes. Thanks for the effort though, you got me past a couple of hard parts.
@fatimamushtaq81328 жыл бұрын
Your tutorial was a big help!! Thank you👍🏼
@lisag90025 жыл бұрын
I think you didn't need to do all those things. I think the main things were removing the top & bottom metal tray. Then you can pull the thing out with pliers. Also, you could have lifted up the mechanical assembly inside if you had removed the 2 screws hidden underneath the rubber pads on the bottom of the case. That would have made things easier for you.
@KL-fj6cg7 жыл бұрын
Your voice kind of reminds me of shrek XD Thank you for the tutorial!
@Anniibbaall7 жыл бұрын
So in the end you still just ended up pulling the plastic with the pliers. Were all of those steps necessary?
@theoverengineer7 жыл бұрын
Necessary to slide the laminate between rollers.
@MrsRabbit8 жыл бұрын
lol the moral of the story ...yeah I got it thank youuu!
@nadkait2 жыл бұрын
I have a whole sheet stuck in the HEATER - its a disaster😪