LandCruiser 80 Series Fender Flares Removal | Step-by-Step Guide

[@matthalpin1981]

Thanks for posting this great video. I have always wanted to know how to do this.

[@dfox344]

Great job. You won my subscription... thank you for sharing.

[@23madventures]

appreciate it! means a lot 👍

[@KiyaWarrior]

I'm planning on taking all of my flares off permanently for a more unique look. 1996 LX450 triple locked here.

[@23madventures]

Would definitely give it a unique look!! Good luck 👍👍

[@Gurrrmedia]

Did you fill your holes?

[@fatmanoverlanding]

👍It would have also been good to see fitting the new flares rubber seal and compare the before and after look. But thanks for sharing.

[@DouglasGreen562]

Very helpful video. Thanks for posting!

[@23madventures]

Appreciate it!! Thanks

[@Fiiitttzzzyyy]

Great video mate! Cheers for sharing 👍🏼

[@Moosaroo]

Awesome. Need to replace the rubber on all my flares shortly and now I can do it w/o breaking shit.

[@williammcneer8357]

Finally🤙🏿

[@bczobel]

And now throw all that plastic in the garbage and plug those holes and your Land cruiser is 8in thinner

[@drwisdom1]

What might be the parts numbers for the needed rubber seals? I recommend using a non-marring plastic pry tool instead of a screwdriver when removing the flares from the body. Informative video.

[@23madventures]

Thanks for the feedback, much appreciated. The manufacture part number was 53851-60020-01

[@fishing4life76]

Can you do a video of how to put the rubber seal on rear flare.

[@23madventures]

Hey, I have already put the rubber seals on the flares but maybe in the future, i will remove and do it again. But put simply, I recommend buying the genuine seals online and then applying the sticky bit to the inside surface of flares tip. Make sure you flares are clean. TIP: I also used superglue in some areas such as bends and sharp edges as it helped to really position the flares and stick it on. If you have any more questions, let me know. Thanks

[@mrawesome2524]

There are access holes in the engine bay to access those without removing fender at all.. Cheers

[@paultew3625]

Can you elaborate

[@normanserail3452]

What saiz rim offset? And tyre saiz