Lantek Punch - Ordering Mesh Holes in Part Module

Lantek support might tell you that reordering holes in the part module for punching machines is impossible and that it "would not be considered a defect and is unlikely to be seen as an enhancement."
However, after spending several hours testing every function-since their names don't always clearly indicate their purposes-I discovered a method to achieve the desired hole ordering for horizontal punching, row by row.
Here's what you need to do:
In the drawing module, go to the main ribbon bar and find the "Modify" section.
Click "Modify."
Click "Regenerate by Selection."
Select the desired machining and right-click.
Check the box for "Simple punching operations - to linear pattern."
Press "OK," and you should see the holes nicely ordered in horizontal mode.
This operation leads to much faster programming in the Nest, saving a lot of time in reordering the chaos.