It goes without saying, always make sure the lower control arm shaft is straight. They do get bent from time to time.
@dansguitarheaven3 жыл бұрын
Thank You Jim, Very informative and helpful, as Im just getting ready to do this. Was stressing some because I don't have the means to weld so like your alternative on the removal. Subscribed and looking forward to more informative videos
@pdiz5 жыл бұрын
Thank you, really helpful stuff.
@Flussig15 жыл бұрын
Thank-you !
@marcelomarek35864 жыл бұрын
Thank you.!
@ronking5878 Жыл бұрын
Hi Jim! Which one do you like better for my first time? I’m about ready to flip a coin. 😊
@1968GTSJimLusk Жыл бұрын
I don't really have a preference.
@thomasward45052 жыл бұрын
Pretty good video but you did not show the things you used to press them in
@highman98363 жыл бұрын
Hi could you please move camera up closer. Thanks
@olhemi14 жыл бұрын
😎👍
@pdiz4 жыл бұрын
How the heck do you paint that thing once the plate is welded on? Do you just dip it in paint?
@1968GTSJimLusk4 жыл бұрын
I just use engine enamel from all angles. There are probably areas inside that don't get great coverage, but it's still better than the factory did.
@claytonhaske3 жыл бұрын
When I try the first method with polyurethane bushings, the shaft pushes through the bushing, and when i try the second method, they don't seat correctly. What do I need to do?
@1968GTSJimLusk3 жыл бұрын
Most poly bushings require you to keep the inner and outer sleeves from the rubber bushings in place. Then they should be easy to push in by hand.
@claytonhaske3 жыл бұрын
@@1968GTSJimLusk I'm sorry, I dont understand what your saying.
@1968GTSJimLusk3 жыл бұрын
@@claytonhaske watch my video on removing the LCA bushings. The stock bushings consist of an outer sleeve and an inner sleeve with the rubber bushing between them. Most poly bushings require that you leave the metal sleeves in place.
@glennwilliams155 жыл бұрын
Got the bushing in but pin not tight
@1968GTSJimLusk5 жыл бұрын
There are a bunch of bushings out there that are too big on the inner sleeve. Quality control sucks right now and I've got a couple of mine that need to be rebuilt that I haven't bought bushings for...
@glennwilliams155 жыл бұрын
@@1968GTSJimLusk yes thank you I am getting new proforge kit summit 100.00
@glennwilliams155 жыл бұрын
Hey Jim got proforge kit dam pins to big for k frame.what bushing do you use
@1968GTSJimLusk5 жыл бұрын
@@glennwilliams15 is it a new pin? B and E bodies use the same bushing, but a larger pin.
@Miwe11382 жыл бұрын
If anyone want a stiffening plates template on PDF i can sell it, you print it and use to cut on the metal sheet 14 gauge. We can use paypal or bank transfer (im in mexico) :D
@manuelromerogutierrez63073 жыл бұрын
Xq no ponen videos en español?
@1968GTSJimLusk3 жыл бұрын
I would have to speak Spanish to make a video in Spanish.