SGP317 Reactance Relay

[@sweezidiers]

9:50 ,the RC branch as connected in series,will be in parallel, Here ,the rc are connected in series but right diagram is when r and c are connected in PARALLEL.

[@jamesowusu-ansah595]

can these inferences be made on the Reactance Relay ( 4 pole induction cup)...Sir please correct me where I'm wrong 1. The Reactance Relay would operate if the Reactance measured in the forward direction by the relay is less than the Reactance setting on the relay and also operate in the reverse direction for all values of Reactance....This can be corrected when the relay is used alongside a directional relay, hence would only operate in the forward direction for values less than Xset 2. Under normal operations, especially for loads whose resistance is very large compared to their Reactance, the relay operates since the Xr

[@jamesowusu-ansah595]

@@lecturesinelectricaleng thank you sir

[@pikuroy3084]

Sir @20:25 why the locus of Zsb & Zsa become perpendicular straight line instead of an inclined one like Z l

[@pikuroy3084]

@15:34 How does the normal load line drawn , is there any equation for it?

[@pikuroy3084]

@18:31 sir pls tell the serial no of thr lecture explaining power swing

[@prabhatlalkarn1880]

sir, could u please kindly explain that why phase shift is required between polarizing coil and operating current coil @12:28

[@chandrashekarablshekara575]

Sir, how to measure the negative value of the X in the transmission line with respect to relay connection point, please clarify

[@Vikranthreddy777]

Sir ,please cover gate syllabus like control system, network theory, signal and system.

[@surendrakverma555]

Very good 🙏🙏🙏🙏🙏 Thanks

[@moulimouli591]

clear sir. thank you...

[@prashantagrawal2352]

can you share slides for quick revision, it would be great help

[@humphrey-be4et]

Why making k1=+ve,k2=0 and so on

[@himanshu2232]

Thanks sir