Ledlenser H8R - Product Demo Video

[@marknichols9271]

Best demo ever seen. No chat all demo. Very clear to see the different aspects. Great!

[@antoniopastor9017]

Hola donde puedo conseguir la h8 o la h15 core gracias.

[@LedlenserMalaysia]

Thanks for your interest, you may check the Ledlenser from your current country. If you would like to purchase through Malaysia, you may check our website: www.ledlenser.my

[@dandyer8351]

Can any 18650 be used

[@LedlenserMalaysia]

Hi, we don't recommend that, as the headlamps comes with charging function, in using not supported batteries may cause the headlamp short-circuit

[@adriantoole4601]

I recently bought this lamp, and also have the h7r.2 which was perfect for me, however, I have a problem with this one, after about 30 seconds of use, the light steps down incrementally in brightness to about half of the starting brightness, even after a full charge, I have had a warranty replacement arrive today, and it does exactly the same thing, surely this isn't normal?

[@LedlenserMalaysia]

Hi Adrian, it's normal on the H8R, as you have activated the power saving mode. The power saving mode helps in giving your headlamps a longer running time, thus it will reduce the brightness in maintaining it till the battery power is low.

[@adriantoole4601]

@@LedlenserMalaysia Is there any way to alter this, as the manual says high/mid/low, not high then lower, mid then lower, low then even lower. When it dims on the lowest setting, it is too dim for loft work, the mid level is too bright for close up work. Why does it do this after 30 seconds, it seems like a fault? Is there any way to keep the brightness that it switches on with? If not Iwill have to return it as it's of no use to me. My H7r.2 stays the same brightness whichever setting it is on, and there isn't a battery issue.

[@LedlenserMalaysia]

@@adriantoole4601 you should be able to find the setting in deactivate the power saving mode in your user manual. Which is the setting for mode three. By setting it, your light should be off, press and hold the power button for around 16 sec, after 3 blink, release the power button. And now your H8R should be under constant light mode and you could have the same brightness throughout.

[@istmih6834]

@@LedlenserMalaysia Yes, the brightness remains the same in mode 3, but it is not 600lm, but only 250lm ! So this headlamp is not 600lm, but only 250lm ! Can the MH10 / H8R headlamps be set to a constant 600lm? Which LED Lenser headlamp has a constant 600lm? Maybe the H7R Core? Thank You

[@LedlenserMalaysia]

@@istmih6834 Yes, perhaps you may consider H7R Core, using 600lumens for max 4 hrs. Besides, you may dimming the light brightness based on your need. You may check our H7R Core unboxing video either: kzbin.info/www/bejne/qn2bl5evoqeVn5Y

[@plop1034]

NO usb typ C :(

[@FootHousePodiatry]

I have bought a ledlenser H8R but the problem is that the light cannot be focused. The bezel is rigid and does not turn, what's the problem here?

[@LedlenserMalaysia]

Hi, the H8R lamp head comes with a focusing function. It might be too tight for the first time you twist as your headlamp is still new or its your first time twisting it. Do hold the silver part on the lamp head and twist clock wise and it shall able to activate the focusing function.

[@sloggisladd]

This is a quality product. But mine won't charge with the power bank. Only with an adapter. Any suggestions on this?

[@LedlenserMalaysia]

It should be workable with power bank. Just wanna double check with you, had you try it with others power bank? (or press the "on" button on your powerbank?) If you are from Malaysia, you may check with us through our website: www.ledlenser.my/contact Besides, there's new product that might help you with it. You may use it as power bank, or directly change the battery to get the full power performance. www.ledlenser.my/accessories/flex3/

[@Littlelamb2023]

Swivel is hard to adjust will it free up it time?

[@LedlenserMalaysia]

Hi Gio, yes. It would become more easier to adjust.

[@hellfather]

Damn correct at the beginning then it lose

[@Thomas-yy9cz]

Why, in maximum mode, consecration falls on it after 1-2 minutes.

[@trophy182]

Dude I have no idea but it drives me insane, my h7r does it and my ih8r. So bloody annoying

[@MichaelNRGRoberts]

Was a design feature to stop it overheating and melting the internal components.

[@LedlenserMalaysia]

Hi, its the Ledlenser control and constant light setting. And it helps to prevent your light from over heating.

[@Thomas-yy9cz]

@@LedlenserMalaysia What kind of overheating can be in a fully aluminum flashlight (MT6), it does not even heat up, it is rather very clever German engineers programmed the driver this way, but the most offensive thing about this is not written in the instructions, and this, among other things, is misleading the consumer, that is, a court case.

[@РоманРоманович-к3й]

good afternoon, I also have a problem, the specifications say that 600 lumens. -10 hours. 250 lumens. 15 hours. but what is it really? 600 lum 1 min. 250 lumens 5 hours maximum. and how is this to be understood? just a shame. after all, when buying, we look at autonomy and power. but in the end we have only half, if all is well !!

[@rayanawa4418]

How much is it?

[@Naeem_Ally]

Hi Guys, could be help assist with my h7.2r , the back light is constantly and red and the refuses to switch on , any help will be greatly appreciated. Thank you

[@LedlenserMalaysia]

Hi Naeem, you may find the full H series product video at kzbin.info/www/bejne/opmVgnR_qbpmq9E After programming your headlamp and the problem you indicated still persist, I would recommend you to contact your region Ledlenser's dealer in having a check on your H7R.2

[@Naeem_Ally]

@@LedlenserMalaysia hi thank you for the reply!, i had to eventually give my torch in for repairs and was advised if it cannot be fixed it will be replaced as the torch is still under warranty:)

[@conzyeire2887]

I just bought this light but inside there was no guarantee activation card😑

[@LedlenserMalaysia]

Hi, I am sorry hear that. Could you share with us where did you make the purchase? You may also contact our customer service at facebook.com/ledlenserworld/ to allow us in better assist you on this.

[@inetmos]

Dear Ledlenser representatives, can you please specify what is the difference between the models H8R and MH10. They look very much the same. What are the differences between them?

[@LedlenserMalaysia]

Hi Audrey, the H8R and MH10 are more of it having the same function, but MH10 comes with a colour filter lense set and also the LED colour temperature is slightly warm in projecting better in giving users a better visual in the outdoor. H8R is design meant for industrial usage with white LED vision.

[@inetmos]

@@LedlenserMalaysia Thank you very much for clarification. I am thinking then of MH10. The filters give some advances with the insect in the forests I guess.

[@LedlenserMalaysia]

@@inetmos yes it sure is. It prevents insects gathered in front of your headlamp while in the woods. You may find the MH10 bundles at www.ledlenser.my/headlamps/mh10-bundle-set/

[@nickm3861]

Good video, but that 'music' is a bad choice.

[@inetmos]

It looks like this headlamp is brining more problems rather than positive moments. It is pity... I was going to buy it and now most likely not.

[@LedlenserMalaysia]

Hi Andrey, please don't worry that the H8R has serves a excellent good performance in functioning and managing it. Perhaps you may share which exact usage you going to use on your headlamp and I could assist to give a better suggestion on your choices? You may also log in to www.ledlenser.my to find out more headlamps selection

[@inetmos]

@@LedlenserMalaysia Still looking at the possibility to get one of led lenser headlamps. Can you explain a bit why the light is decreasing after 30 seconds of use as described at some messages bellow? Some of the reviews are saying about saving mode. Can it be the reason?

[@LedlenserMalaysia]

Hi @@inetmos, yes it's due to the power saving mode that caused the brightness of the headlamp to decreased after 30sec. But you may set the "constant current" mode in preventing your headlamps light to decrease and maintain the brightness till the battery run off. Which also means that, by setting the "constant current" mode may causes your headlamp with a shorter running time too.