LIVE CENTER DIY

[@asdwee4444]

Cosmin, felicitari pentru clipul bine facut si pentru idee .Calitatea clipului e de nota 10 . Ca si rulment as fi utilizat rulmenti pe role de compresie . Succes pe mai departe

[@JIMMY916]

Multumesc mult Lenard! Conteaza mult pentru mine aprecierea ta. Ai dreptate! Rulmentul nr. 2 trebuia sa fie axial dar imi complica " lucrarea " prin asigurarea ungerii acestuia si etanseitatea ansamblului. Sper ca marimea rulmentilor sa poata suplini lipsa lui Daca nu .... modificam.😂

[@petruciucur]

Excelenta lucrare, felicitari. Se poate vedea la lucru?

[@JIMMY916]

Multumesc pentru apreciere! In filmuletele viitoare ne vom satura de el ! 🤣

[@samrodian919]

5 months down the line, how have you found it Jimmy? I'm not sure I'd have used two standard ball race bearings without a thrust race between them. Normally there is a front shield threaded into the end to locate the bearing stack and to stop chips getting into the end bearing. Those rubber seals won't keep out oily chips and worse, oily rust particles from getting inside. Also I think the sliding fit of the removable point will allow too much radial play caused by the cutting tool pressure. I hope I am wrong !

[@JIMMY916]

It's my only option. With good and bad..

[@JIMMY916]

The two bearings are still holding up. At that moment I chose the simplest method. Today (probably) I would do it differently.

[@iosifignat5972]

Wow. Cool!!

[@christianheidt5733]

You never want to press-fit a bearing by pushing on the inner race, just sayin'. Cool project 👍.

[@JIMMY916]

Is pressed against the outer ring of the bearing not of the inner race. Thank you for your comment

[@christianheidt5733]

@@JIMMY916 sorry my bad 😞.