LX1 and Lightburn - Setup, configuration and testing.

[@richard8031]

THANKS for the info... I'll be setting my LX1 later today...

[@1amPain]

The site for the configuration files won't let me download it like you did. The DOWNLOAD button does not appear in the top right corner. Can you share the file you downloaded or show us the settings for the file so we can enter them manually?

[@michaeltrone616]

Any idea how I can get my LP3 to connect to Lightburn?

[@JosephShaw-t3u]

Can you please reply !!!!!!!!!!!!!!!!!!!!!! I followed your instructions to the tee. when i try downloading the drivers it dosent let me. Once I put my curser on the download button it says unable to download. How do i fix this ????????

[@vivianstefannymahechasanch4844]

hi! sorry, were you able to solve the problem? the same thing happens to me and I don't know what to do....thank you!

[@schmots]

I hadn’t seen lx1 config files before only lp4. Thanks for that. Cheers

[@schmots]

I still don't have this working 100%. I can do engraves with lightburn, but if I want to do cuts, at some point in my run, beginning, middle, end... the laser will just stop. The LED will turn RED, but the laser doesn't turn off... I can hit stop on lightburn and that will turn off the laser and then I can home, but I can't start another job without power cycling the laser. I have yet to get anything more than a single square to cut out when running from lightburn.

[@filipeaguiar561]

Thanks for this video, very helpfull to setup lightburn. One question, Im using the 10w like you and i cant engrave Faster than 4800mm/min or 80mm/Sec. When i setup the speed to Higher it Will engrave the same way as 4800. Are you having the same issue? Or are some settings Im not using right? Thanks in advance, once again thank you for this video, very helpfull.