Machinist Tips and Tricks Volume 3

[@greggroos2271]

Washer on the drill, priceless. Putting a couple of big washers in the drill case this morning

[@Reillysluck458]

Wow. Was expecting a clickbait with something stupid like smacking a part with a hammer on a lathe to align it. Very nice surprise! Actually learned a few things! Keep these coming!

[@mikemoore5929]

Keep 'em coming brother .

[@atomichydrogenweld2823]

a plethora of great tips.......thank you so much, an old fart in Florida

[@ramanaswamy6947]

Waser trick 👌

[@berntsteinmetz8564]

great video !

[@roytaylor2355]

How old are you? Or do you have some dinosaurs in your shop?

[@ronaldpatton5668]

Dude, sometimes old school is the easiest way.

[@darrenersmit824]

Old school is the best way

[@DonMason-cv6og]

CNC. Conventional not. Complicated

[@steveclark..]

Does the washer trick work on short drill bits too?

[@sansanych46lot22]

Микрометр пластмасовый, детский? Почему такой маленький?

[@avijitDrilling92]

👍

[@KDN775]

Was soll die Scheibe am Ende bringen?

[@ayrendraganas8686]

hilft den bohrer senkrecht zum werkstück zu halten; einfach versuchen die scheibe balanciert in der mitte zu halten.

[@markspencer9672]

It's called a deburring tool. Don't fill the internet with your lack of knowledge.

[@drewbuckley8139]

Tough crowd jeesh, theres different types of deburring tools, one of which he shows later in the video. If you just call the first one only a deburring tool, i bet most people are going to imagine the one he showed 2nd

[@DonMason-cv6og]

Twist a burr. By Vargas