MAG SPECHT 600 L: Machining of a turbocharger housing + simulation

Machine with pallet changer, linear motors and integrated draw-bar spindle; Machining the turbine inlet rear face; Finish milling turbine inlet; Roughing the main bore by multi-edge boring bar; Interpolation turning of the main bore using highly dynamic linear motor drives (X/Y/Z); 10 contoures are finish machined with the same facing head; Interpolation turning of the v-band contour, to reduce the cutting forces; Simulation machining of compressor housings with multiple-workspiece fixture

[@gredangeo]

The cross section view was a pretty nice touch.

[@Koast11Koast]

Are those inserts made to cut with no coolant running or is the coolant neglect just on for the demo? How do they not break?

[@Thefreakyfreek]

some inserts work better without coolant they get realy hot during the actual cut and than the coolant jet hits it and it cools again the insert gets brittle an tip chatters this mostly aplyes on the fast and heavy cuts but in this video i think that is mostly for demo purpose