Maiden Flight P-51D Mustang 20cc Hangar 9.

P-51D:
*Engine: DLE 10RA
*Prop: 16x8 Master Airscrew
*Servos: Hitec HS-485HB Deluxe Ball Bearing Karbonite Gear
*Gas servo: Savox SC-1251MG
*RX batt.: 6.6V 3000mAh LiFe Battery Egobatt
*Ignition batt: 6.6V 2200mAh liFe Battery Egobatt
Music by:
*News Room News mp3 ! No copyright music free download
🔊Free download - www.file-up.or...
*Autostrade mp3 Free Download: zipvale.com/Grq4

[@nomi86cool]

Good landing that was unlucky bounce

[@blakjack3053]

Yes, let the P51 "fly" while the main wheels are still on the ground. Seen so many a pilot pull too soon, and rotate by way of pure thrust only to have their P51 eat sh!t after the low altitude tip stall.

[@LICobra]

Did you mean a DLE20RA ???

[@angeladavid100]

Hello good flight but I see that the plane is very messed up where the pilot is Does the plane cover have wrinkles?You can repair this with the hot iron or by stretching the cover, thanks

[@daanvandeneynde6925]

Hi David, Yes it has wrinkles it's the covering .I still have to smooth it back with heat gun or hot iron . thanks for the tip and the response.

[@angeladavid100]

@@daanvandeneynde6925 thankio

[@guitarcleveland]

Nice flying. What transmitter are you using?

[@daanvandeneynde6925]

I use frsky Horus x10s but am switching to tandem x20s .thanks for the interest.

[@guitarcleveland]

@@daanvandeneynde6925 Thank you

[@nomi86cool]

Can i ask what size fuel tank you are using looks better than the ones comes with it and also what these plugs called you used with wiring

[@daanvandeneynde6925]

Hey, It is a 300ml tank, brand Kuza. rcdiesel.eu/products/fuel-tank-with-filter-300ml?variant=32946803835020 MPX Multi-wire Servo Plug that's the name of the plugs. aerobertics.be/en_be/extrext2xp?qty=1

[@angeladavid100]

Hi again and sorry to ask but are the trains you use on the plane connected directly to the receiver or are they powered by a separate battery?thankio

[@daanvandeneynde6925]

My ignition has its own battery and my receiver has its own battery.

[@TheMrzekerz]

Hoi Daan! Die eerste vlucht ziet er goed uit! Ik ben in de laatste bouwfase van deze Hangar9 P51. Komende weken zal de eerste maiden plaatsvinden. Op mijn P51 zit een Saito Fa125a gemonteerd op methanol icm CDI in plaats van gloeiplug. Nu heb ik een vraag; in de bouwhandleiding staat vermeld dat de 'aileron throws' bij mid op 18mm/16mm staat. Dat lijkt enorm veel? Welke instelling heb jij voor jouw Mustang?

[@daanvandeneynde6925]

Beste, Bij deze mijn instellingen. Low rates: -Elevator: 17mm -Aileron: 14mm -Rudder: 28mm Mid rates -Elevator: 20mm -Aileron: 17mm -Rudder: 28mm High rates -Elevator: 24mm -Aileron: 22mm -Rudder: 28mm 45% Expo Flaps -Half: 15mm -Full: 34mm Veel succes met de maiden.

[@TheMrzekerz]

Dank je voor uw snelle reactie 👍

[@nomi86cool]

How much weight did you putted to get cg correct

[@daanvandeneynde6925]

I had to add 250 gr to get the right cg.(cg 155mm).

[@angeladavid100]

Hello again, how are you? A question what oil do you use to mix in gasoline? Thanks

[@daanvandeneynde6925]

Hey David Stihl HP Ultra 2-stroke Oil I use.

[@daanvandeneynde6925]

Mixing ratio 1:30

[@roysyntageros4191]

Nice video! Any problems with overheating with the DLE20RA?

[@daanvandeneynde6925]

Hello Roy, thanks for the comment. I have not encountered any problems with the engine,I did 6 flights and had no problems with overheating.

[@aryannouman2962]

I had problems with over heating dlr 20 but made holes with drill where exhaust is on cowl other than that I have richen both needles to have fearless flight which does comprise on power

[@aryannouman2962]

*dle

[@nomi86cool]

What size and volt battery are you using for receiver and retracts

[@daanvandeneynde6925]

hello, I use, RX batt.: 6.6V 3000mAh LiFe Battery Egobatt Ignition batt: 6.6V 2200mAh liFe Battery Egobatt kind regards Daan

[@edgardojagr216]

What servos did you use??

[@daanvandeneynde6925]

Hitec’s HS-45HB,and for gas i used a Savox SC-1257TG Digital Servo .