MAJOR Wheel Balancer CB-3550, Aluminum Mode

I created this video with the KZbin Video Editor ( / editor )

[@woody_teacher]

Thanks for the advice. Great video ... simple, short and to the point. Well done !

[@karlmawby2921]

Blows my mind how far it's ce since the bubble balancer I started out on....

[@user-uo9kq4sk2c]

If you calibrate in dynamic mode, will the calibration for ALU-S be accurate? Or do you need to run a calibration in ALU-S mode?

[@CHIBA280CRV]

Sir thanks, this was a very informative video , sure helped me a lot ..🙏👍🏼👍🏼👍🏼👍🏼👍🏼

[@Mrdubomb]

Im almost always out 1/4 to half on the first spin, guaranteed, brand new machine, what am I doing wrong?

[@mattzhang5348]

call Jim for a tech support, or i can get Jim to call you.

[@mattzhang5348]

what is your phone number?

[@jimromani3670]

Hi first make sure machine is calibrated well you should get 0.00's most of the time in one spin, in dynamic mode hammer weights. If you are only getting the .25-.50 in Alum-S mode then your measurements are off. I recommend a fabric tape measure from the dollar store and enter your wheel inside diameters into the machine before mounting on the machine. The diameters go in .1 increments. If you just roughly guess the diameter this will cause .25-.50 to show a second time.

[@Mrdubomb]

You are correct, it is only in alu-s mode Ill try what you suggest

[@Mrdubomb]

generally when I am alu-s mode I am using clip on for the inside, should that measurement be whatever the tire diameter is?

[@nathanmciver6496]

Lol! Awesome! If I didn't like the video, it was because of the machine! Great explanation! I found another machine that seemed like the interface looked alot easier to navigate! You have to be there and it should be what the persons preferance is!

[@ujash2003]

Garbage machine not a flat rate machine, have to measure everything manually

[@tirechangerca]

Hi Kumar, how much you bought this machine? we have automatic one.

[@user-uo9kq4sk2c]

If you calibrate in dynamic mode, will the calibration for ALU-S be accurate? Or do you need to run a calibration in ALU-S mode?

[@tirechangerca]

calibrate it in dynamic will work for all modes including ALU-S.