Making a cast net by hand, Knitting needle by hand.

Рет қаралды 1,260

Күн бұрын

Пікірлер: 16

@timmurphy3104 10 ай бұрын

Tim here. Thank you Mr. Mike and Phil for the RAPID response to my questions AGAIN. Going to work on making the right size needles now. I have this episode saved also. GREAT WORK!!!

@mikeusina73 10 ай бұрын

Tim, I'm sending you a needle.

@jamesb1307 9 ай бұрын

Hey Mike, would It be possible to buy a needle from you.

@mikeusina73 9 ай бұрын

@@jamesb1307Where are you?

@jamesb1307 9 ай бұрын

I am in South East Georgia.@@mikeusina73

@louisoyugi837 9 ай бұрын

I have got my net about one foot in length and with great luck got the wideners all neatly in line. My wideners are now 5 meshes apart. I am doing the met with a 3/4 of an inch with an extra cm gauge. Following your invaluable advice I will get to a point of making my met. Thanks

@mikeusina73 9 ай бұрын

Sounds good, keep up the good work.

@johncapo3497 10 ай бұрын

Good to see you, Mike.

@louisoyugi837 9 ай бұрын

Hey, Mike and Phil. I am now at my seventh plain row and was it knots I could not tie or untie... How to tie the first 41 meshes was hard. I almost had 6 meshes and so much tied up together one after the other. I made expanders as well as meshes together on the 1st row.

@louisoyugi837 9 ай бұрын

I almost had 6 meshes and so much wideners tied up together on the first row. I think you got it right when you got to say as an experience that could happen at the first row... I love you all. And Phil your camera shots works great it does wonders.

@louisoyugi837 9 ай бұрын

Hello, I have gone over my seventh plain mesh row. I made a count of the wideners going about the first widener row. If I made a count through that eigth row of the wideners that would be and I was getting 13 wideners finishing with 3 plain meshes. Now does each widener row after the first 13 wideners row be started with one mesh and a widener after that?

@louisoyugi837 9 ай бұрын

I will get into watching the ones where there are wideneners