Making a Mini Table Saw ( Powerful and practical )

Рет қаралды 29,175

Күн бұрын

Пікірлер: 45

@ToBeeOrNotToBeHoney 10 ай бұрын

Proof that if you don't have a mill, a lathe can be used as one... Creative use of a lathe to mill the slot in the first part of the video... Although we would call this a Radial Arm Saw, which are much more dangerous than a table saw when not used properly (sure yours is tiny, but even then a blade guard is a good idea). In a full size radial arm saw the material is pressed up against a stop on the back side since the blade will tend to pull the material in that direction. Holding is against the front stop will allow the stock to get pulled into the blade along with your thumb...

@dandocus160 Жыл бұрын

Nice Professional Video and Professional Product

@metallantik 11 ай бұрын

Thanks ❤️

@homemadetools Жыл бұрын

Nice little table saw. We shared this video on our homemade tools forum this week 😎

@metallantik Жыл бұрын

Thanks a lot ❤️🙏

@edirahmat8310 Жыл бұрын

Dengan menonton nya mata saya kenyang pekerjaan yg propesional bagus

@metallantik Жыл бұрын

Thanks a lot ❤️🙏

@Ramvideo 10 ай бұрын

It's a good idea, but in the video you can mostly see the lathe and not the object being made

@yusufabdrahman592 Жыл бұрын

So good ii boss 💪💪👍👍

@metallantik Жыл бұрын

Thanks ❤️🙏

@fahi8293 Жыл бұрын

فوق العاده 😍🌹🌹

@metallantik Жыл бұрын

❤️

@paulmccullough7352 11 ай бұрын

An engineers approach at a mini table saw. not very approachable for the average maker, but still great to see a different variation on something that is over done by everyone else.

@metallantik 11 ай бұрын

❤️

@itarry4 Жыл бұрын

Love the idea seems a bit over engineered for the size and strength of the motor though. How about stripping down an old drill and using the motor and battery system from that. This would give you variable speeds and a clutch on the system. Still as I say love the build and the work done on the build.

@metallantik Жыл бұрын

Thank you very much for your comment 🙏❤️

@siirousshahkaramii8628 Жыл бұрын

very nice brawo vowwwww

@metallantik Жыл бұрын

🙏❤️

@yeagerxp Жыл бұрын

Excellent work but!!!! Is it not annoying there is always a but!! 🤣🤣BUT!!! you forgot the angle gauge, 90 degree cuts are fine, but what about 15 degree and 45 degree cuts 😂STILL Excellent work👍👍👍. Thank you for sharing. Be safe 🇨🇦

@metallantik Жыл бұрын

Absolutely correct, but in the future I have a video in which I made changes to this product and it has a protractor and the motor is placed below 😀😁 ، I hope I have explained correctly . Thanks a lot 😘

@yeagerxp Жыл бұрын

@@metallantik Yes you explained correctly. I understand