Making and Fitting a BRAND New Floor - VW Transporter Conversion - Builders Van to Luxury Travel

[@GillPalmer]

Really neat job! What a contrast to the inside of Lucky when you bought him!

[@jonnytootall1239]

Good job, I need a deeper side step as my flooring is quite a bit higher than the original 👍

[@TeeeTV]

I wanted thicker flooring but the seat bracket surrounds limited me to a certain height, ended up with 9mm ply

[@jonnytootall1239]

@@TeeeTV I got a two plus one seat from eBay that came with a new cushioned rubber floor covering so it fitted perfectly for the seat mount brackets, it’s just that it’s about half an inch above the old step cover🤣 it does however dampen a lot of noise from the back and it’s easy to clean👍

[@TeeeTV]

@@jonnytootall1239 I’d love a section of that rubber matting just to go behind the seats where I store tools and stuff to protect the floor! It’s probably not that hard to get my hands on it I just need to get round to it

[@thatsykes]

Oh! Didn’t expect to see you here!

[@TeeeTV]

Here I am!

[@jasonpugz]

Hi what size packers did you use ? Thanks

[@TeeeTV]

Packers were 9mm but my floor is VERY uneven since previous owner was not gentle! Some places the floor is so raised/dipped that I couldn’t even use packers

[@chrisdavison2022]

Shouldn't that thermoflor be shiny side up, same with all thermal reflective stuff...???

[@TeeeTV]

I went over and over that thought process before putting it in, I really couldn’t decide, it might be the wrong way round but I’m not even sure if it would make a difference