Very cool video. I could watch different bracing configurations fail for hours!
@kevinwan63923 жыл бұрын
Interesting video. Thanks for posting.
@StructurePlanet3 жыл бұрын
Thank you.
@alvahmacwilliam1982 жыл бұрын
Very helpful. In your next video please off the music when you are speaking. Thank you.
@meisamkabiri63713 жыл бұрын
The main failure is mostly like local bending in bottom chord or local buckling of this member?
@StructurePlanet3 жыл бұрын
I think it was a member buckling under compression load.
@stanlee22002 жыл бұрын
You need to put your truss kickers (the yellow tensions on a 45 degree angle) the other way instead of going from the top left to bottom right they should go from top right to bottom left if looking at it as in your thumbnail for the over hang and then reverse the ones on the table as well.
@calvoh9715 Жыл бұрын
@@stanlee2200 it is a cantilever bending, the diagonals should be in tension, how he has placed them is correct. if he puts them as you say, they will be in compression, which is not good since the structure is supposed to be as light as possible.
@Q.H_DIARIES3 жыл бұрын
reverse your triangle form that mid point remove the straigt one
@ganiputra33903 жыл бұрын
I dont reallu understand can u explain more pls? I need your help