Makita Cordless Impact Driver Drill DHP481 DIY Diagnose and repair

[@Winston-hw8wb]

Hi there, so what was the problem? Mine after 5 years no abuse, stopped working.. Intermittent motor signal. but the gearing seems ok. Could be the switch? Thanks

[@powertoolsclinic]

Change the controller ass'y/ or contact your local makita distributor or dealer in your country

[@Winston-hw8wb]

Hi, there I didn't get it fully.. sir. Did you replaced the trigger switch or cleaned? Compressed air or what.. contact cleaner? Same tool same issue.. only my led lights do light up but the motor seems somewhat stuck.. sort of erratic sounds.. but seems alive. Thanks💪

[@powertoolsclinic]

Ah ok this machine tries to spray contact cleaner on any brand on part not available contact cleaner I used WD40 but it's good you use contact cleaners any brand

[@salvagedsteelstudio]

How the hell did you remove the chuck?

[@MrUnknownName]

It's a very unprofessional video. I didn't even get any knowledge by watching this. And yes, I guess someone edited or clipped out that part of the video and replaced it back in the video where this "professional" "repair person" eventually showed how the chuck was removed in it's wholeness. The gears of the momentum wheels should never really be replaced like that on the inside of this drill, because dragging all dirt back together in the drill from the table and everything else is so nasty!

[@powertoolsclinic]

Ok, try to remove the chuck of this model DHP481 if easy. Just send me a video of how you remove thanks

[@MrUnknownName]

@@powertoolsclinic You must learn how to write first of all without grammar mistakes and other language barriers and then you can contact me. My message to you was clearly about something else other than a disassembling of a Makita DHP481 hammer drill.

[@jetstream9559]

I wanted to learn that too...🙄

[@amobenpro]

Replacing everything doesn't mean you repaired anything. You didn't even check the parts of the device.

[@powertoolsclinic]

That's why I replaced it because some people don't know how to replace ok

[@yh1461]

where do you get the tool that connects to the transmission?

[@powertoolsclinic]

What transmission? Gear Complete you can contact your local Makita distributor or dealer in your country

[@yh1461]

I mean the tool you put on your the back of the gear assembly to rmove the chuck. The tool you put in the workbench vise

[@powertoolsclinic]

AH okay the special tools to remove the drill chuck DIY tools only sir

[@cales_junior_2.020]

Thanks!