The 1oz and 2oz measurements are on the cap. You just pour what's left or use the cap for less than 2oz measurement.
@allybaylus61492 жыл бұрын
There are measurements on the lid for anything below two ounces…
@irfansiddiqi40715 жыл бұрын
You review a product, but can't remember key points such as how much it cost, how much water to add and how long to place in microwave? It would be useful to know how many times a single bottle can be used before desposing of it.
@dianejudd Жыл бұрын
It's 20ml of water for 3mins in the micro
@Rajafaizee6 ай бұрын
How to warm the anticolic bottle, I have Tomme Tippe bottle warmer should i warm up the milk in this as well
@aaronvanessacwik33246 жыл бұрын
My son loves his Mams bottles , he's used them since he was born. I do agree with you on the user error part, they will leak if you don't put the bottle together properly .
@kjehg5 жыл бұрын
Anyone have trouble with bottles flowing just like a stream and not stopping first time mum and I don’t get it I thought they were suppose to drip ?
@adityavimal75244 жыл бұрын
I found this happens if you heat the milk by putting the bottle in hot water to warm the milk. If the cap is on the heat causes a pressure build up and that shoots the milk out like a stream.... we open the top to equalise the pressure, and then it drips out. Also, depends on which number that your using. 0 drops, but we noticed that 1 streams. Hope this helps... our little one is just over 2 weeks old and I'm trying to work out how to ensure the venting works 100% as the valve in the base should allow air in while feeding to equalise the pressure,, thereby reducing how much sucking against the pressure baby has to do, which in turn reduces wind. It's not always successful, the valve, and I'm wondering if it is user error or product error. Any ideas anyone?
@AtheneA51237 жыл бұрын
Dr Browns were good but a pain to clean.. glad you didn't get them. XX
@adityavimal75244 жыл бұрын
our little one is just over 2 weeks old and I'm trying to work out how to ensure the venting works 100% as the valve in the base should allow air in while feeding to equalise the pressure,, thereby reducing how much sucking against the pressure baby has to do, which in turn reduces wind. It's not always successful, the valve, and I'm wondering if it is user error or product error. Any ideas anyone?
@DaniCha4 жыл бұрын
Are you making sure there’s no water stuck between the silicone and the plastic at the base? That can cause the air from not flowing through.
@fatherandsonspropertymaint99796 жыл бұрын
how do you make a video and not remember half the info your talking about
@LolaPahola5 жыл бұрын
Julio Trejo don’t watch her if you just watch her videos to criticize her. At least she has the guts to make them.