Manual control of DC servo motor using encoder/MPG input on DCS-3010

[@watahyahknow]

looks like the thing i need to make a variable transmission i need to set the up and down motoion using a closed loop steppermotor fitted with a crank to the exact rotation of an electric motor fitted with an encoder the whole setup is a honing machine based on a drillpress , i need the up and down motion in combination with the spinning (bout 800rpm to create a 45 degree honing pattern , and if the bore gets larger or smaller that pattern changes (as the honing stones move faster or slower along the wall depending on the diameter using the same rpm )

[@Neleroluyor35]

where can i buy?

[@ptmove]

You can find our products on: www.prizma.rs/ml/index.php/motion-controls or send your request on e-mail: [e-mail] Regards

[@cesaryehuda7373]

You probably dont give a shit but if you're bored like me during the covid times then you can stream all the latest series on InstaFlixxer. I've been streaming with my girlfriend lately xD

[@jaxsonariel2151]

@Cesar Yehuda yea, been watching on instaflixxer for months myself =)