13 Types of Conveyor Belt Damage

[@migratorybird3187]

Good explanation Thank you for this valuable information❤

[@martinengineering]

We're so glad you found it helpful. Thanks for watching.

[@ishaqalbusaidi7191]

Thank you for sharing your knowledge.

[@markhamilton2469]

Hello Jerad I dont agree with the 2 areas of heat damage. To me it looks like soft skirt damage over historic heat damage? Ot the heat of the product has caused the soft skirts to damage the belt more in the skirt line?

[@martinengineering]

Hi Mark, thanks for the comment and thanks for viewing the video. I certainly agree with you that skirting could create belt damage. Especially if the skirting used was not specified correctly for the application. If I recall this photo correctly, this plant did have severe enough mistracking that it did cause the belt to run into structure. That may be the reason for this damage, but it may also be due to skirting problems. Most likely, it's probably some of each. I should add that it's our recommendation to place the skirting system a bit further in than the very outer edge of the belt. The intent for this is to allow for what we call "free belt edge." When sufficient free belt edge is taken into consideration, it allows the use of a dual-lipped skirting system. Dual-lipped skirting systems will contain dust better, when dust is an issue. In a new installation or an upgrade, we would typically narrow the chute wall a bit to allow the skirting to not lay so close to the edge of the belt. I don't know if that was the case in this application. If it were, the the skirting damage would be more noticeable about 2" in from the outer edge of the belt. Appreciate your input!!

[@blessinglebaka3072]

I am working on a machine learning project where my model learns to identify these faults in conveyor belts. Could anyway kindly sugest a link with a datset of images so I can train my model

[@ishaqalbusaidi7191]

What does it mean if the belt is torn vertically ? From top to bottom

[@martinengineering]

Hello! We are assuming your description of vertical would be that the tear is along the length of the belt, rather than across the width of the belt. If that assumption is correct, then you are asking in regards to a long tear that is typically caused by the belts running or operating. This should mean there is some sort of metal, sharp enough and strong enough that is stationary and is damaging the belt as the belt passes by it. You should inspect the structure closely in the area where you are seeing the damage for what might be causing the damage.

[@ishaqalbusaidi7191]

@martinengineering thank u Mr. Martin

[@harshitamishra-lm5uc]

How to identify our belt running is in over tension

[@martinengineering]

The best way to identify that a conveyor belt is over tensioned is to observe it while running without cargo or material. If the belt elevates or rides up out of the troughed rollers or idlers, then the belt is most likely over tensioned, which will lead to belt cupping.

[@beachboardfan9544]

How about a belt that tracks centered on the pullies until its loaded, then tracks to one side?

[@martinengineering]

When a belt tracks correctly unloaded but then mistracks when cargo is added, it's almost always a loading issue. As a belt is loaded, the force can push the receiving belt to one side or another. This is typically observed by the cargo settling to one side or the other of the belt. Segregated loading can also cause problems when large pieces of cargo and small fines are conveyed together, often before crushing or other processing. It's most common on perpendicular transfer points. Each of these problems can be avoided. Don't hesitate to get in touch with us to schedule a meeting via Zoom if you'd like to discuss further

[@amandeep1254]

Hi, i have some photos of airport conveyor belts , im not able to figure out root cause, can you pls share your mail id or suggest were i can share photos to discuss.. Thanks