Introduction video to 3d model creation in Mastercam.
Пікірлер: 5
@mnojkl321711 ай бұрын
hails, from Washington State. This was helpful - thanks for posting this. Just a note - when you are creating the second hole you read the dimension off as ".438, in the X" but enter .538 - I'm assuming this was just a small error? I spent almost a half hour trying to figure out why the extra .100 .... :D
@matthewk53252 жыл бұрын
My mastercam doesn’t seem to have the same sort of levels function? I got the 2022 hle?!
@BrianWickhamMFG2 жыл бұрын
It should. What is not the same?
@matthewk53252 жыл бұрын
@@BrianWickhamMFG sorry I did actually figure out how to access and pull up that section. I’m not sure I understand the exact point of levels and how they work though? I’m very new to cad/cam! Thank you so much though your videos are excellent
@BrianWickhamMFG2 жыл бұрын
@@matthewk5325 Levels are all about organization and are user preference. Check out some of my other content, I put stock, different fixtures, part geometry etc. on different levels as needed to help my work flow.