Mastercraft Boat Digital to Analog gauge swap Step by Step DIY

[@rontanis1024]

I just saw this, great job!! The 05 M-C wiring is different that the 04' and we consider this to be the most difficult kit to install, again GREAT JOB! . 1998-2002 M-C's are very easy to do.

[@jamesfisher-x8q]

Can you tell me about your dual battery setup

[@JeremiahMartinson]

How do you know that the new temp sensor will trip the engine light or overheat alarm? (How is it tied to the ECU?)

[@_willalexander.88]

Mine never had the light but did have the alarm. I'm not worried about it bc I put an electric water pump in place of the mechanical and it's working great. I'm always conscious of my gauges though.

[@brianbullock5463]

Can I bring my boat to you? I ordered the hardness, and I am totally lost.

[@brianbullock5463]

Is it possible for you to do my boat?

[@roeybukay6226]

Hi, I have an issue with my boat, which is exactly the same model as the one you're showing-MASTERCRAFT X10. When I go out for a sail, the gauges work normally. However, when I restart the boat after turning it off in the water, the boat starts up, but the gauge panel doesn’t turn on. I usually have to try starting it a few times until the gauges start working again. What can I do?

[@_willalexander.88]

@roeybukay6226 that's how mine started to go. I had to cycle the key a few times, then start when I hear them chatter. What I would do first is follow the ground wire from battery to motor, disconnect, clean well and reconnect. Check all connections on battery. Clean and reconnect. See what that does for you. Very important the ground to the motor. There very sensitive.