Matryx 7S Display Installation - Polaris Snowmobiles

[@JAnderson-j7g]

That was MUCH better video on how to install 7s! Thank you

[@betheleskimo9680]

Glad this video shows how the wires are routed, because 75 miles on the new machine the GPS plug and the v2v cables came undone and I didn’t know where to plug them back in and to re-secure the cables

[@Ryanbalazs]

Just so everyone knows. If you’re adding this to a sled that does not have 7S on it to begin with, you will need to power up wiring harness, As well as a power up antigravity battery. CV Customs has both. If you do not add this power of wiring harness it will not save any of your tracks and will not see if any of the information after your sled is off for more than two minutes.

[@123789timothy]

Why do you need a antigravity battery?

[@matbike9546]

@@123789timothyso it can run with sled off, if it already has a battery and starter you might not be able to start it after if you use the screen for too long

[@MPJohnny5]

So even if your sled has an electric start and battery already ?

[@matbike9546]

@@MPJohnny5 yes

[@relavantoccurence94]

What size

[@tucker83]

Is there a way to transfer miles onto this? Mine now says zero miles

[@helodriver41]

Can this be done on a 22-23 switchback xc?

[@TheKimmey281]

How much does this cost compared to snowchecking it

[@davidrowley8251]

The 7SDD gauge 2884971 costs $1300 US, and the Required Installation kit 2884972 $120 US. Of course when doing this, you will have a few takeoff parts including the original Message Center gauge. This gauge can only be installed on Polaris Matryx sleds.