Mav's Fab Shop Ep. 1: welder teardown and Yamaha IT175 First start.

[@teaganhutchison1062]

My buddy has a problem with his 1981 it250 we can't find out what's causing it but there's too much gas going into the cylinder and it's not burning it goes into the expansion chamber. The float hight is correct, the jetting is correct, the timing is correct so we don't know what caused it but it would fowl the plug immediately. Very odd. Great video by the way👍

[@mavsfabshop]

That is odd. I'm new to two strokes, so this is going to be a learning experience for me, and thanks!

[@nathandavis1770]

hes scared rhe jeep is gonna give his welder 2nd hand electrical problems.

[@mavsfabshop]

Man I hope not lol

[@treyallison8153]

🤓 Umm excuse me safety man wants to know where your cut resistant gloves are while your cutting that fule line. And did you have a hot work for that lighter use?

[@mavsfabshop]

Naaahhh, you don't need all that!