Maximize Your Tools with the Magnetic Chisel Rack

This is the first of three videos about getting my tools out of my travel chest and on too my French Cleat Wall. This magnetic chisel holder is a great way to keep chisels protected while conveniently located close by at all times!
For each of these three builds, I am using designs based on other youtubers who has influenced my woodworking journey and KZbin channel these last few years.‪@RobCosmanWoodworking‬ has been a big influence on me so I based my design for this off something he built a while back.
Chapters:
00:00 - Dovetail Frame Construction
01:01 - Panel Installation
01:41 - Lower Chisel Guide
02:21 - Upper Magnet Holder
04:29 - Recap
🌲 Subscribe for more woodworking projects: kzbin.info/door/3Rt...
🌳 Get current project updates on Instagram: /StumblingBearWoodcraft
/ stumblingbe. .
🌴 Share this video with a friend: • Maximize Your Tools wi...
🌲 See some of my other woodworking project videos here: kzbin.info?list...
#stumblingbearwoodcraft

[@StumblingBearWoodcraft]

Project Plans are Now Available at www.StumblingBearWoodcraft.com! Get your first project plan free using code FirstPlanFree at checkout! www.stumblingbearwoodcraft.com/products/magnetic-chisel-rack

[@JankyPlanks]

Good stuff man!

[@StumblingBearWoodcraft]

Thanks!

[@SW-jo7vy]

What kind, source and size magnets did you use? Going embed magnets, then 1/16" thk venier over. Want the Goldilox strength magnet. Good build and vid. Thx

[@StumblingBearWoodcraft]

These are the ones I used: Nexlevl Super Mini Fridge Magnets... www.amazon.com/dp/B01NAL9I5H?ref=ppx_pop_mob_ap_share

[@johnford7847]

Very nice, clean design. Does the chisel acquire magnetism over time, and if so, does it cause any issues with, e.g., sharpening? Thanks for sharing.

[@StumblingBearWoodcraft]

From what i read before building it, no. It's not right on the magnet. it just has a small amount of pull, enough to keep from falling off, but ask me again in a year. :)

[@aarontrovillion9285]

I love this. Gonna steal this idea! Any reason why you used the table saw rather than the band saw to resaw the piece with the magnets in it?

[@StumblingBearWoodcraft]

Yeah, my bandsaw doesn't have a big enough clearance for that piece. Bandsaw would have been easier if it would fit.

[@CallmeSam00]

1:03 Have to point out, this is very unsafe. I know from first hand experience. Did exactly this, got kickback and the saw went straight through the fingernail and bone of my middle finger. Took almost half a year until i got most of the use of that finger back and even that was entirely due to the skilled hand surgeoun I had the fortune to catch on duty at the local hospital that day. Only reason I even still have that finger, albeit with permanent nerve damage and an interesting scar is because I did this on a tiny Proxxon table saw that has a much smaller blade. This large table saw you're using would mostly leave piecemeal of that finger.

[@CallmeSam00]

But sorry, don't want to criticise your video! I'm already planning to make a chisel rack similar to what you are making there. Thank you for sharing :)

[@StumblingBearWoodcraft]

Good call, I should have had the piece secured down and raised the blade into it to be safer.

[@StumblingBearWoodcraft]

All good! Good luck!