Procedure: 1. In PSpice Schematics draw the main circuit above. 2. For the value of RL enter {R} rather than a numeric value like normal. 3. Select the Voltage/level marker and place a marker above RL as shown in the figure. 4. Now,click on the DRAW>GET NEW PART menu. 5. In the field under PART NAME, enter PARAM. Click Place&Close. 6. Double click on the PARAM.In the popup window enter R in the NAME1 box, and 10 in the VALUE1 box. Click SaveAttr and close the window. 7. Fromthe menu select Analysis>Setup. 8. Enable the DC SWEEP box, and open the DC SWEEP Options. 9. Under SweepVar. Select Global Parameter. 10. In the Name box enter R. In the Start Value box enter 1. In the End Value box enter 150. In the Increment box enter 1. 1. Select OK to close the window. 12. Now Run the simulation. 13. In the plot window double click on the text label _ V(RL:2) or_V(RL:1). The ModifyTrace window should open. 14. If the trace expression shows V(RL:2) change it to- V(RL:2)*I(RL). 15. The plot demonstrating maximum power is obtained.
@rajuganneboina1232 жыл бұрын
RL=30 Is the maximum value of load resistance is to be variable upto 30 i.e 0 to 30
@BindiyaSudarsun Жыл бұрын
THANKYOU Sir!
@dinakarkr5870 Жыл бұрын
Sir,Could you please tell the syntax for finding S parameters in Pspice A/D